28 January 2021 in Engineering Reports
Basic Oxygen Furnace (BOF) steelmaking is the main method for steelmaking production, mixing efficiency of BOF vessel would greatly affect the uniformity of chemical composition and temperature in molten steel. Therefore, this paper conducted the effect of blowing parameters on bath mixing efficiency during BOF steelmaking process. Through measuring the mixing time of steel bath in BOF vessel, the effect of different blowing parameters was studied. Based on analysis of variance for the experimental results, the influence degree on mixing efficiency by different blowing parameters was acquired, and the optimized combination of blowing parameters was obtained. Moreover, the mixing index which indicated the mixing degree of steel bath in BOF vessel was proposed in this study, and an apparent nonlinear relation was acquired after determining relationship between the mixing index and blowing parameters. The optimal blowing parameters were applied to an 80 t industrial BOF vessel in a special steel plant, the end point carbon and oxygen equilibrium was decreased from 0.0032 to 0.0026, end point phosphorus and total Fe content in slag were reduced by 0.0012% and 2.21%, respectively. The mixing index and results presented in this work could be helpful to improve mixing efficiency in commercial BOF vessels.
29 April 2021 in Mathematical Problems in Engineering
In order to mitigate the seismic response of a cable-stayed bridge, a new type damping device named asymmetric pounding tuned mass damper (APTMD) is developed in this paper on the basis of the traditional symmetric pounding tuned mass damper. The novel APTMD has three parameters to be determined: the left-side gap, the right-side gap, and the frequency ratio. A numerical model of the APTMD damping system is established with consideration of both the computational efficiency and accuracy to enable the parametric optimization of the damper. The numerical model is based on a simplified model of the cable-stayed bridge and a nonlinear pounding force model. The genetic algorithm is utilized for the optimization of the damper. Afterwards, the cable-stayed bridge is subjected to 20 recorded ground motions to evaluate the vibration control effectiveness of the APTMD. Four systems are considered: (1) without dampers; (2) with a TMD; (3) with a PTMD; and (4) with an APTMD. Time history analysis reveals the following: (1) those dampers can all effectively suppress the vibration of the bridge and (2) the vibration control effectiveness of the APTMD is slightly better than the TMD and the PTMD.