Two-dimensional (2-D) wireless power transfer (WPT) systems can be controlled by either the directional method or the rotational method. The rotational method refers to the use of omnidirectional transmitter generating rotational flux regardless of the load positions, while the directional method refers to the use of omnidirectional transmitter generating magnetic flux directly toward the power-consuming load directions. This article compares the overall efficiency of the two methods for 2-D WPT systems. Theoretical analysis reveals that the directional WPT can be more efficient than the rotational WPT with either single or multiple loads when the magnetic field vector is controlled within the feasible zones; and the efficiency difference between the two methods are more significant when the dimensions of the receiver coils are smaller. Both simulation and experimental results are consistent in validating the two discoveries. They indicate that the averaged efficiency of the directional method is at least 5% higher than that of the rotational one.
9 December 2021 in IEEE Transactions on Power Electronics
This article addresses some practical issues of the Japan Electronics and Information Technology Industries Association (JEITA) battery charging guidelines and common industrial practices. The issues involve the temperature-dependent charging profile that may not lead to optimal charging time. A hybrid temperature-regulated current control (HTRCC) is proposed and compared with common JEITA charging profile in order to minimize the charging time within the thermal limits of the battery. The form factor of the charging current is used for a quick verification that HTRCC can shorten the charging time. Based on an electro-thermal battery model, the minimum charging speed improvement rate compared to JEITA charging profile is also predicted. Practical measurements of the charging profile and charging time are included to confirm the theoretical analysis.
24 July 2020 in IEEE Transactions on Power Electronics
While detection of foreign or unintended metallic objects is an important topic for wireless power transfer (WPT), operation of WPT systems with intended metallic objects is largely an unchartered territory. This paper presents a methodology for analyzing the effects of intended metallic object on a WPT system through the study of the magnetic field distribution and the use of a reduced-order equivalent model of the systems for comparing the WPT system with and without the metallic object. The methodology is applied to a metallic corona ring of low resistance used with a WPT system. The analysis quantifies how an intended metallic object could change the magnetic coupling between the transmitter and receiver coils, and alter the equivalent resonant tank parameters of the WPT system. Re-compensation of the resonant tank can only enhance the power transfer capability but not the energy efficiency. The theory and practical verification of a new performance-enhancement method based on a combination of (i) re-compensating the resonant tanks and (ii) maximizing the equivalent mutual inductance of the Tx and Rx coils is presented. Such methodology provides a general approach to analyze WPT systems with or without relay resonators in the presence of intended metallic objects.
29 August 2019 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This paper presents the design, analysis and verification of a ball-joint structure suitable for capacitive wireless power transfer (WPT) for a consumer electronic lighting system. The WPT structure consists of ball-joint component rotatable inside a spherical socket. Conductive plates are used to form equivalent plates so that capacitive WPT can be achieved through electric field coupling. One unique feature of this novel structure is that the mutual capacitance almost remains constant in the rotatable angular range. The design and theoretical analysis are included and practical results obtained from a 7 W prototype are included to confirm the theory.