1 September 1996 in Renewable Energy
31 August 2010 in Biomass and Bioenergy
12 October 2022 in International Journal of Renewable Energy Development
Biogas upgrading is essential in order to increase the calorific value and improve the quality of raw biogas. This present study aims at investigating the optimum performance of a near atmospheric pressure water scrubbing (NAPWS) system for biogas upgrading while using both the adsorption and absorption techniques. This was achieved through a two-stage process: namely, the Taguchi approach followed by the response surface methodology (RSM). The Taguchi orthogonal array design consisted of 27 runs where the raw biogas pressure (10 - 30 kPa), liquid flow rates (2.6 - 4.2 l/ min.) and variations of the steel wool height (0 - 45.72 cm) in the adsorption column were experimentally studied with respect to the methane (CH4) yield and removal efficiency of hydrogen sulfide (H2S) and carbon dioxide (CO2). From the experiments, the removal efficiency of hydrogen sulfide was greater than 87% with the average bio-methane content of 77.67%. During the second-stage, the analysis of variance (ANOVA) and the RSM were undertaken for optimization of the process parameters. The optimum bio-methane concentration of 84.71 (%v/v) CH4 and 13.31 (%v/v) CO2 was attained at gas pressure of 14kPa, liquid flow rate of 4.2 l/min., and steel wool height at 22.86cm obtained through numerical optimization. These results revealed that the utilization of the Taguchi and the RSM yielded to the best optimal system performance with the liquid flow rate as the most significant factor
5 November 2014 in Energy Science & Engineering
An experimental apparatus has been developed to evaluate the drying process of green tea leaves. Tea drying is an energy-intensive process which results in the removal of leaf moisture; it is essential to the quality of the final product. In order to more efficiently use process energy, a prototype drying system has been built and tested. The prototype incorporates a rotating perforated drum which helps speed the drying process. Experiments were carried out with multiple temperatures, airflow rates, and drum rotation rates; a subset of those results is shown here. In particular, the impact of airflow rate on the process was studied. It was found that as the airflow increased, the drying rate increased, as expected. However, the efficiency of energy use, which was quantified by the Specific Energy Consumption rate, varied considerably with flow. While higher flows led to faster drying, it resulted in a lower energy efficiency. Also, a two parameter predictive model was developed that was able to accurately match the moisture removal rates for a very wide range of flows. This predictive model, which is based on thermal-fluid fundamentals, can be used to extrapolate the presented results to cases which were not considered.
30 September 2025 in Journal of Energy Systems
This work presents the performance of three solar water heaters equipped with 2 m2 flat plate collectors. The experimental setup included a copper absorber plate manufactured in China (System C), along with two locally built flat plate collectors. One collector was made of aluminum material (System A), while the other was made of galvanized steel material (System B). The systems were tested over a period of three months. For systems A, B, and C; the average maximum outlet water temperatures were measured as 74.1 oC, 69.4 oC, and 78.7 oC, respectively. Systems A, B, and C had mean water outlet temperatures of 61.2 oC, 57.3 oC, and 63.5 oC, respectively. The efficiency of the aluminum-based flat plate collector was 32.8%, slightly below the copper-based flat plate collector, which reached an efficiency of 34%. On the other hand, the galvanized flat plate collector exhibited the lowest thermal efficiency of 28.8%. It can be inferred that even though the galvanized steel solar water heater had low thermal efficiency, it was 20% more cost-effective than systems constructed from copper and aluminum. These results would contribute to the widespread adoption of the inexpensive solar water heaters produced in the region as a reasonable alternative to conventional energy sources including biomass.