1 July 2020 in Metallurgist
1 September 2025 in Tribology in Industry
The selection of materials with high mechanical and tribological properties defines current trends in modern materials science. In this paper we investigate the use of alloying elements, such as phosphorus (P), manganese (Mn), tin (Sn), antimony (Sb) and lead (Pb), in order to improve tribological characteristics in Cu-based self-lubricating materials. Using structural (XRD, OM) and chemical (EDX, XRF, XPS) analyses we observed distinctive elemental segregation and diffusion towards the surface under mechanical pressure, driven by elevated temperatures. Additionally, we perform GDOES in order to prove the dynamics of element migration towards the surface under working conditions. The latter is very important, because new phases, such as Pb0.8Sb0.2, SnPb2O4, Pb2O, Cu3P, etc. are formed and located near the surface, which improves the tribology in situ. The role of these phases is diverse and differentiated, such as directly lowering the friction coefficient (FC) and as a consequence lowering the temperature, which under operating conditions is over 700 °C. Alloying elements also lead to improved hardness. It was found that the friction coefficient in vacuum dropped as much as 40 times and the wear at load 40 N dropped 4 times in compared the pure copper sample.
1 September 2025 in Journal of Physics: Conference Series
Ti-Al-V alloys are mostly used in the aerospace and automotive industries as light material with good strength and elasticity. However, it shows some drawbacks, such as high friction coefficient especially at elevated temperatures, as well as fast oxidation and deterioration of its chemical and crystal structure. Thus, it turns improper its use where the surface properties are of importance. The present study aims to cover this alloy with a protective layer of thickness up to 3 microns with especially pronounced compositional gradient character in order to minimize these drawbacks. The gradient structure is essential to assure a good adherence, especially required at high temperature and stress. The chosen protective coatings are based on Ti-carbo-nitride multilayers (TiCN), providing outstanding hardness, exceeding 30 GPa, while keeping low friction coefficient and excellent adhesion properties even under extreme conditions. The coatings were deposited by Physical Vapor Deposition (PVD). The adhesion is an important quality and the present study shows that near the interface, the both Young's modulus at the adjacent materials are close.