Research Institute of Electrochemical Energy, National Institute of Advanced Industrial Science and Technology, 1-8-31 Midorigaoka, Ikeda, Osaka 563-8577, Japan
Auto-generated profile, based on publicly available information
Noboru Taguchi
Research Institute of Electrochemical Energy, National Institute of Advanced Industrial Science and Technology, 1-8-31 Midorigaoka, Ikeda, Osaka 563-8577, Japan
High-entropy alloys (HEAs) have attracted considerable attention to improve performance of various electrocatalyst materials. A comprehensive understanding of the relationship between surface atomic-level structures and catalytic properties is essential to boost the development of novel catalysts. In this study, we propose an experimental study platform that enables the vacuum synthesis of atomic-level-controlled single-crystal high-entropy alloy surfaces and evaluates their catalytic properties. The platform provides essential information that is crucial for the microstructural fundamentals of electrocatalysis, i.e., the detailed relationship between multi-component alloy surface microstructures and their catalytic properties. Nanometre-thick epitaxially stacking layers of Pt and equi-atomic-ratio Cr-Mn-Fe-Co-Ni, the so-called Cantor alloy, were synthesised on low-index single-crystal Pt substrates (Pt/Cr-Mn-Fe-Co-Ni/Pt(hkl)) as a Pt-based single-crystal alloy surface model for oxygen reduction reaction (ORR) electrocatalysis. The usefulness of the platform was demonstrated by showing the outperforming oxygen reduction reaction properties of high-entropy alloy surfaces when compared to Pt-Co binary surfaces.
9 February 2018 in The Journal of Physical Chemistry C
Scanning transmission electron microscopy-energy dispersive X-ray spectroscopy measurements performed on Cu(In,Ga)Se2 (CIGS) thin-film devices grown with RbF postdeposition treatment (RbF-PDT) revealed the formation of a RbInSe2 compound at the p-CIGS/n-CdS heterointerface. However, this type of Rb-compound formation was not observed with elemental In-free ternary CuGaSe2 (CGS) devices. The film surface of CIGS grown with RbF-PDT was found to be Ga-depleted; thus, the practical interface structure turned out to be CIGS/(CuInSe2, RbInSe2)/CdS. In contrast to the significant improvements observed in In-containing CIGS photovoltaic device performance with RbF-PDT, no significant improvements have been observed in In-free CGS devices thus far. These results suggest that the presence of elemental In plays a key role in obtaining beneficial alkali Rb effects for enhancing device performance as well as surface modification with RbF-PDT.
For the development of better cathode catalysts for use in polymer electrolyte fuel cells, Pt/C catalyst is modified with poly(melamine-co-formaldehyde) methylated (PMF) by simple coating treatment directly on an electrode. Although this modification almost halves the electrochemical surface area due to PMF covering the Pt surface, the mass activity of the oxygen reduction reaction (ORR) is increased ca. 2-fold. This indicates that the ORR activity of uncovered active sites of Pt is increased by ca. 4-fold by this modification. A similar improvement of ORR is also observed after a Pt/C catalyst electrode is dipped into aqueous solutions of some aminated 1,3,5-triazine derivatives including melamine. These aminated 1,3,5-triazine derivatives such as PMF and melamine positively shift the redox peaks of the adsorption/desorption of OHad which can act as an inhibitor of ORR on Pt. This could result in higher ORR activity.