Spray deposited porous CIGS nanoparticle-derived thin films were selenized in a two zone rapid thermal annealing furnace and effects of various selenization parameters including Se evaporation temperature, flow rate of carrier gas, and substrate temperature on densification of the CIGS layers were investigated. It was found that higher Se supply to CIGS nanoparticles either by increasing Se evaporation temperature or by increasing the flow rate of carrier gas resulted in larger CIGS grains with higher degree of crystallinity, while it also induced formation of a thicker MoSe2 layer in-between CIGS and Mo which resulted in partial detachment of CIGS/MoSe2/Mo layers from the glass substrate. Densification of CIGS layer by growth of nanoparticles and formation of thick MoSe2 were explained by a liquid Se assisted reaction rather than by a vapor phase Se assisted reaction.
A newly developed hybrid ink of binary CuS nanoparticles and In precursor solution was prepared to form a CuInSe2 (CIS) thin film. Previously, we have shown a CIS thin film solar cell with 4.19% conversion efficiency using the hybrid ink of Cu2−xSe nanoparticles and In precursor. Deposition using hybrid ink offers advantages including the provision of stress-relief and crack-deflection centers by pure material based nanoparticles and effective binding with the nanoparticles by precursor solutions without other organic binders. Here, we demonstrate volume expansion of a thin film for forming a well-grown absorber layer using CuS nanoparticles instead of Cu2−xSe. Binary nanoparticles were synthesized by a low temperature colloidal process and a precursor solution was prepared by using a non-toxic chelating agent to disperse the In component stably. The band gap of the CIS thin film was 1.08 eV, as determined by external quantum efficiency (EQE) measurements, and the reproducible conversion efficiency of the fabricated device was 6.23%.
1 November 2005 in Journal of Mechanical Science and Technology
The Cu(In,Ga)Se2(CIGS) film was deposited on Mo-coated sodalime glass by three stage co-evaporation of elemental In, Ga, Cu, and Se sources. The Se flux during the co-evaporation has great influence on the microstructure of CIGS layer. The surface region of CIGS film showed pores when the Se flux was large. The conversion efficiency of CdS/CIGS solar cells was depended on the CIGS surface morphology. The best CIGS solar cell was obtained at 15 Aring/s Se vapor pressure condition and it had the following photovoltaic parameters: conversion efficiency of 17.57%, Jsc=36.48 mA/cm 2, Voc=0.655 V and FF=73.5% in an active area of 0.421 cm2