The growing demand for alternative technologies, of clean and sustainable nature, has fostered the development and improvement of equipment that uses solar energy for the dehydration of seeds and fruits. Such equipment has been used worldwide for hundreds of years; however, it remains uncommon in Serra Gaúcha, a region of great production of grapes and apples for natura consumption in the state of Rio Grande do Sul—Brazil. In order to investigate the economic and technical viability of solar dryers in the Serra Gaúcha, this work has as target the design, simulation, construction, and experimental analysis of an Indirect Passive Solar Dryer with Chimney. The prototype, divided into three parts: solar collector, dehydration chamber, and chimney, was built prioritizing materials of low cost, but that did not compromise its performance. The device was submitted to experiments, which observed: solar collector behavior very close to the simulated one; obtaining a coefficient of performance of 87% in the equipment; satisfactory rise in temperature at the collector outlet comparing to its inlet; and dehydration of apples with a reduction of 89% in mass with 32.78 MJ of energy delivered to the system. The prototype payback period was estimated in two years.
The use of fossil fuels and the greenhouse gases emission is a growing concern of the international community. For this reason, the research and development of alternative sources are forcing down the costs associated with renewable energy sources. Photovoltaic energy production is the best example of these exponential growing rates at the last years. However, the output power provided through the photovoltaic conversion process depends on solar irradiation, and the daily and seasonal movements directly affect the intensity of radiation received in the solar collectors. In order to optimize the energy production, this paper describes the development of a low-cost, dual axes solar tracker (DAST) with low power consumption. The work encompasses the design, construction, assembly of the entire mechanical structure, electrical systems and devices and the elaboration of the control logic responsible for all the movement of the module to search the position of maximum solar irradiation. The tracking is designed through the use of LDR sensors responsible for providing the input signal to a microcontroller. The PV panel rotates automatically based on the sun irradiance during the day while at night, the panel remains in a horizontal position to protect the mechanical structure against inclement weather. The proposed system also has a development of a 12V battery charging system used for module movement and as a power source for electronic devices. Results show that a system with the designed DAST can reduce in 8% the payback of a single PV installation when compared with a fixed structure, taking in account the solar irradiance available in the region of Serra Gaúcha in South Brazil.