1 April 2017 in Review of Scientific Instruments
A large-strain, torsional deformation apparatus has been developed based on diamond anvil cells at high pressures, up to 135 GPa with a help of hard nano-polycrystalline diamond anvils. These pressure conditions correspond to the base of the Earth’s mantle. An X-ray laminography technique is introduced for high-pressure in situ 3D observations of the strain markers. The technique developed in this study introduces the possibility of the in situ rheological measurements of the deep Earth materials under ultrahigh-pressure conditions.
28 November 2017 in Progress in Earth and Planetary Science
The Earth’s lower mantle is composed of bridgmanite, ferropericlase, and CaSiO3-rich perovskite. The melting phase relations between each component are key to understanding the melting of the Earth’s lower mantle and the crystallization of the deep magma ocean. In this study, melting phase relations in the MgSiO3–CaSiO3 system were investigated at 24 GPa using a multi-anvil apparatus. The eutectic composition is (Mg,Ca)SiO3 with 81–86 mol% MgSiO3. The solidus temperature is 2600–2620 K. The solubility of CaSiO3 component into bridgmanite increases with temperature, reaching a maximum of 3–6 mol% at the solidus, and then decreases with temperature. The same trend was observed for the solubility of MgSiO3 component into CaSiO3-rich perovskite, with a maximum of 14–16 mol% at the solidus. The asymmetric regular solutions between bridgmanite and CaSiO3-rich perovskite and between MgSiO3 and CaSiO3 liquid components well reproduce the melting phase relations constrained experimentally.
1 April 2016 in Earth and Planetary Science Letters
3 November 2017 in High Pressure Research
A rotational diamond anvil cell is the most suitable deformation apparatus with which to investigate the rheological properties of deep-Earth materials at pressures similar to those found in the lower mantle and core. However, slip between the sample and piston is still a problem, since the slip prevents the attainment of a constant strain rate and interferes with the uniform deformation of a sample. In this paper, we report that using a diamond anvil with deep grooves results in a marked improvement in the coupling between the sample and the diamond anvils.
4 November 2022 in Geophysical Research Letters
The seismic anisotropy observed in Earth's lowermost mantle (D″ layer) is thought to originate from the lattice‐preferred orientation (LPO) of mantle materials induced by plastic deformation. Ferropericlase is the second most abundant mineral in the lower mantle, and its LPO induced by deformation may significantly contribute to the seismic anisotropy in the D″ layer. The slip system(s) of ferropericlase controlling the LPO in the D″ layer is still controversial, owing to technical difficulties in conducting high‐pressure deformation experiments. We conducted shear deformation experiments on MgO under pressures of up to 120 GPa and reported the LPO after the deformation experiments. Our results indicate that {100} is the dominant slip system in the D″ layer. The LPO developed during shear deformation would result in shear wave splitting with VSH > VSV, consistent with seismic observations in the regions expected to accommodate large shear strain by subducted slabs in the D″ layer.