In this study, the La/Sr ratio and A‐site deficiency of (La 1−y Sr y ) x Cr 0.5 Mn 0.45 Ni 0.05 O 3−δ (LSCMN) were systematically varied to investigate the effect of these modifications on lattice parameters, surface composition, and initial electrochemical performance. Studied materials were thermally treated in oxidizing and reducing gas environments and thereafter analyzed using X‐ray diffraction (XRD), time‐of‐flight secondary ion mass spectrometry (TOF‐SIMS), and electrochemical analysis methods. X‐ray analysis of samples heat‐treated in air revealed that the La/Sr ratio influences the Mn 3+ /Mn 4+ ratio in LSCMN material, but the influence of A‐site deficiency is minor. After thermal treatment in a highly reducing environment, expansion of lattice parameters was observed, caused by the reduction of Ni 2+ to Ni 0 and partial reduction of Mn 4+ to Mn 3+ and simultaneous formation of oxide ion vacancies. The highest lattice changes were observed in the highest Sr concentration and at the 1%–3% A‐site deficiency range. The highest electrochemical activity was observed when the Sr content remained low ( y = 0.2). The most stable systems had low A‐site deficiency. The study reveals that chemical and structural characteristics of the electrode surface, particularly the segregation of LSCMN components, play an essential role in the electrochemical performance and stability.
Layered Ruddlesden–Popper oxides provide a versatile platform for topochemical anion modification, enabling access to metastable mixed-anion phases with tuneable structural and electronic properties. In this work, we present a comprehensive investigation of how mixed B-site (indium and antimony) chemistry influences topochemical fluorination of Ba 2 In 0.5 Sb 0.5 O 4 using PVDF. Powder X-ray diffraction reveals anisotropic lattice expansion, dominated by elongation perpendicular to the perovskite layers, with minimal change in the in-plane lattice parameters. Fluorination proceeds through a composition-dependent multiphase regime in which several tetragonal ( I 4 /mmm ) RP components with progressively expanded c and slightly contracted a lattice parameters coexist, representing a distribution of fluorination states, followed by convergence to a single dominant fluorine-rich tetragonal phase at high fluorine content. Coupled X-ray/neutron Rietveld refinement establishes the end member as the anion-saturated oxyfluoride Ba 2 In 0.5 Sb 0.5 O 2 F 4 , and locates the three fully occupied anion sites of the tetragonal I 4 /mmm framework. The preferred O/F distribution, with oxide at the equatorial site and fluoride at the apical and interstitial sites, is supported by bond-valence-sums (BVSs) analysis of the refined interatomic distances and the corresponding global instability indices (GIIs), together with charge balance, since O and F cannot be reliably distinguished from their neutron scattering lengths alone. XPS confirms that In remains in the +3 oxidation state, while the Sb spectral changes are consistent with modifications of the local O/F coordination environment rather than changes in the formal oxidation state. X-ray absorption near-edge structure measurements further support the retention of the formal In 3+ and Sb 5+ oxidation states upon fluorination.