This paper discusses the fabrication, wireless performance, and reliability of graphene-based passive ultrahigh-frequency radio-frequency identification (RFID) tags on a fabric substrate. The conductive ink comprising functionalized graphene nanoplatelets is deposited directly on a cotton fabric substrate to fabricate the tag antennas. After attaching the chips, the tag performance is evaluated through wireless tag measurements before and after high-humidity conditions, bending, and stretching. Initially, the peak read range of the tag is about 1.6 m, which increases to 3.2 m in 100% humidity conditions. Additionally, after drying, the performance of the tag returns back to normal. In a bending test, the read range of a bent tag decreases below 1 m. Furthermore, the read range of the tag in a nonbended state gradually decreases and is about 1.1 m after 100 bending cycles. According to our measurements, stretching has a serious detrimental effect on these tags and they cannot be considered stretchable. However, these initial results show that this low-cost and eco-friendly graphene RFID tag has a remarkable and unique response to moisture and high reliability in harsh bending conditions. Overall, it also has a strong potential to be used in future wearable sensor applications.
5 June 2017 in International Journal of Antennas and Propagation
We present the possibilities of 3D direct-write dispensing in the fabrication of passive UHF RFID graphene tags on a textile substrate. In our method, the graphene tag antenna is deposited directly on top of the IC strap, in order to simplify the manufacturing process by removing one step, that is, the IC attachment with conductive glue. Our wireless measurement results confirm that graphene RFID tags with printed antenna-IC interconnections achieve peak read ranges of 5.2 meters, which makes them comparable to graphene tags with epoxy-glued ICs. After keeping the tags in high humidity, the read ranges of the tags with epoxy-glued and printed antenna-IC interconnections decrease 0.8 meters and 0.5 meters, respectively. However, after drying, the performance of both types of tags returns back to normal.
1 January 2017 in International Journal of Antennas and Propagation
This paper introduces 3D direct writing and microdispensing of graphene ultrahigh frequency (UHF) radio-frequency-identification (RFID) antennas on textile, wood, and cardboard substrates, subsequently cured either by conventional oven or photonically by pulsed Xenon flashes. Photonic-cured passive UHF RFID graphene tags on cardboard, wood, and textile substrates achieve read ranges of 5.4, 4.6, and 4 meters, respectively. These results are superior to those achieved by the oven-cured tags that featured read ranges of 4.8, 4.5, and 3.6 meters, respectively. This work presents the first integration of 3D printing and photonic curing of graphene antennas on low-cost versatile substrates.
In this paper, we investigate the fabrication and wireless performance of graphene-based passive UHF RFID textile tags. Two different graphene-based inks were used to fabricate identical antennas on a fabric substrate by doctor blading technique. The performance of the tags was evaluated with wireless measurements throughout the UHF RFID frequency band. Based on our results, the graphene-based tags showed attainable read ranges of 1.6 and 2.4 meters. According to these first results, these tags have a great potential in future wearable applications along with cost-effective and eco-friendly aspects.
26 September 2020 in International Journal of Antennas and Propagation
In the article titled “3D-Printed Graphene Antennas and Interconnections for Textile RFID Tags: Fabrication and Reliability towards Humidity” [1], the Acknowledgments section should be corrected as follows: