1 January 2020 in Advances in Civil Engineering
This paper presents the results of an experimental research designed to investigate the dynamic mechanical properties and constitutive model of fiber reinforced concrete (FRC), including steel fiber reinforced concrete (SFRC) and polypropylene fiber reinforced concrete (PFRC) under fast loading. Experimental results are achieved by using the electrohydraulic servo loading test method, implying that the dynamic mechanical properties of PFRC and SFRC, such as peak stress, peak strain, and toughness, are positively affected by strain rate. The experimental elastic modulus test results of FRC with different fiber contents indicate that the elastic modulus is positively affected by polypropylene or steel fibers and increases with the increment of fiber content. Finally, the experimental stress‐strain curves obtained in the MTS electrohydraulic servo system test are fitted by a damage dynamic constitutive model of FRC. The good fitting with experimental results proves that the model could be appropriate to describe the dynamic mechanical properties of FRC.
1 January 2020 in Advances in Civil Engineering
This paper presents the results of an experimental research designed to investigate the combined effects of corrosion rate, concrete cover thickness, and stirrup spacing on the bond performance between reinforcement and concrete of reinforced concrete (RC) specimens. The RC specimens were immersed into sodium chloride solution to eliminate the passivation film on reinforcement. Then, an accelerated corrosion method was applied to corrode reinforcement embedded in concrete specimens. Pullout test was carried out to establish empirical formulas for ultimate slip and ultimate bond strength of RC specimens with three different corrosion rates, different concrete cover thicknesses, and different stirrup spacings. In addition, the bond‐slip relation model was developed to predict and evaluate the bond performance of RC specimens. Finally, the ultrasonic technology was used to detect the damage of RC specimens, and the corresponding nonlinear coefficient β was proposed to characterize the damage degree of RC specimens. The susceptibility of β on the damage of specimens was compared with that of ultrasonic velocity, indicating β was more appropriate to evaluate the damage of RC specimens.
14 September 2020 in International Journal of Concrete Structures and Materials
This paper investigated the working behavior characteristics of six reinforcement concrete (RC) beams subjected to bending based on the numerical shape function (NSF) method and structural stressing state theory. Firstly, the structural stressing state mode is expressed based on the generalized strain energy density (GSED) derived from the measured strain data. Then, one of the Carbon Fiber Reinforced Plastic (CFRP)-strengthened RC beams is taken as an example and the leap characteristics of RC beam’s stressing state are detected by applying the Mann–Kendall (M–K) criterion, updating the existing definition of the structural failure load. Accordingly, the stressing state modes and strain fields of the CFRP-strengthened RC beam are proposed to reveal their leap characteristics. Furthermore, through comparing the working performance of six RC beams, the effects of different strengths and different reinforcement ratios on CFRP strengthening performance are investigated. Finally, the NSF method is applied to reasonably interpolate the limited strain data for further revealing the stressing state characteristics of the RC beams. The research results explore a new analysis method to conduct an accurate estimation of the structural failure load and provide a reference for the future design of CFRP-strengthened RC beams.