In this paper we present experimental data on heat transfer and pressure drop characteristics at flow boiling of refrigerant R-134a in a horizontal microchannel heat sink. The primary objective of this study was to experimentally establish how the local heat transfer coefficient and pressure drop correlate with the heat flux, mass flux, and vapor quality. The copper microchannel heat sink contains 21 microchannels with 335 × 930 μm² cross section. The microchannel plate and heating block were divided by the partition wall for the local heat flux measurements. Distribution of local heat transfer coefficients along the length and width of the microchannel plate was measured in the range of external heat fluxes from 50 to 500 kW/m²; the mass flux varied within 200–600 kg/m²-s, and pressure varied within 6–16 bar. The obvious impact of heat flux on the magnitude of heat transfer coefficient was observed. It showed that nucleate boiling is the dominant mechanism for heat transfer. A new model of flow boiling heat transfer, considering nucleate boiling suppression and liquid film evaporation, was proposed and verified experimentally in this paper.

Regularities of methane conversion in the presence of water steam were obtained experimentally while activating chemical conversions on the inner convex wall of an annular microchannel. The steam methane reforming was done on the Rh/Al₂O₃ nanocatalyst with the heat applied through the microchannel gap from the outer wall. Concentrations of the products of chemical reactions in the outlet gas mixture are measured at different temperatures of the outer microchannel wall. The range of channel wall temperatures at which the ratio of hydrogen and carbon oxide in the outlet mixture grows substantially is determined. Data on the composition of methane conversion products for the ratio H₂O/CH₄ = 1.77 and the activation energy of methane steam reforming at reactor outer wall temperatures of up to 880°C are obtained. The effect of the radiation heat exchange and the external diffuse limitation on the rate of chemical conversions in methane steam reforming in an annular microchannel with external heat supply is determined.

This paper presents an experimental study of the structure of an upward gas-liquid flow in a vertical microchannel with a cross-sectional dimension of 0.67 × 2.00 mm and a length of 0.5 m. The tests were performed in the ranges of reduced rates of nitrogen 0.04–11.00 m/sec and water 0.07–0.41 m/sec. Using the method of two-beam laser scanning, we identified the main flow regimes (slug-bubble, slug, transient, emulsion, and annular) and determined the statistical characteristics of the two-phase flow. A map of flow regimes was constructed, the dependence of slug velocity on the reduced mixture velocity was obtained, and the friction factor for an upward gas-liquid flow in a microchannel was measured.