Supported amines are promising candidate adsorbents for the removal of CO2 from flue gases and directly from ambient air. The incorporation of additives into polymeric amines such as poly(ethylenimine) (PEI) supported on mesoporous oxides is an effective strategy to improve the performance of the materials. Here, several practical aspects of this strategy are addressed with regards to direct air capture. The influence of three additives (CTAB, PEG200, PEG1000) was systematically explored under dry simulated air capture conditions (400 ppm of CO2, 30 °C). With SBA-15 as a model support for poly(ethylenimine) (PEI), the nature of the additive induced heterogeneities in the deposition of organic on the interior and exterior of the particles, an important consideration for future scale up to practical systems. The PEG200 additive increased the observed thermodynamic performance (∼60% increase in amine efficiency) of the adsorbents regardless of the PEI content, while the other molecules had less positive effe...
A series of alumina-supported Fe-based catalysts is prepared via a dry impregnation method in the presence of a phosphorous source (phosphate salt) and then used for the catalytic dehydrogenation of propane. Specifically, supported catalysts with Fe:P molar ratio of 1:1, 2:1, 3:1 are prepared and their chemical composition, textural properties and redox properties are characterized with an array of techniques. In the non-oxidative dehydrogenation (PDH) of propane at 600 °C and atmospheric pressure, the most active catalyst (Fe:P ratio of 3:1) exhibits 15% propane conversion and >80% C3H6 selectivity. The calculated activity is 9.9 mmol/h/gFe (mass basis) or 13 µmol/h/m2 (surface area basis), with a corresponding TOF of 19 h-1. During the initial stages of reaction under PDH conditions, the precatalyst is reduced and Fe(0) species are generated, eventually giving way to iron carbide species. During this induction period, significant carbon is incorporated into the catalyst and propylene selectivity is low. Only after the iron carbide phase appears does the reactivity and selectivity achieve steady state conditions with high propylene selectivity and good activity. The addition of the phosphorous source in the pre-catalyst is found to be important in obtaining a catalyst with superior performance.
MoS2–C microspheres have been demonstrated with excellent electrochemical performances in terms of low resistance, high capacity even at large current density, and stable cycling performance.