1 October 2019 in Computer Networks
FCFrancisco R.P. Cavalcanti
Francisco R.P. Cavalcanti
19 April 2013 in EURASIP Journal on Advances in Signal Processing
27 January 2021 in IEEE Transactions on Vehicular Technology
The generation of spatially consistent random variables (SCRVs) in R2 and R3 described by a predefined autocorrelation function (ACF) is an important feature for channel modeling in fifth-generation (5G) systems. However, most of the existing ACF models only provide strictly non-negative (SNN) correlation and the ones that provide negative correlation are mostly non-positive semi-definite (PSDe). Motivated by this and also by measurements found in the literature, this paper proposes an ACF model that extends the exponential decaying ACF by allowing negative correlations. The model is proved to be PSDe in R2 and R3 and its capability to fit channel measurements in millimeter-wave (mmWave) bands is also analyzed. Furthermore, it is provided an analytical derivation of a sum-of-sinusoids (SoS) method capable of generating a Gaussian process (GP) in R3 characterized by the proposed ACF. The proposed SoS method is compared to a state-of-the-art (SoA) solution and presents gains up to 13 dB and 1.5 dB in terms of spatial-mean-square error (SMSE) and mean square error (MSE), respectively, while demanding lower computational complexity.
6 May 2020 in IEEE Wireless Communications Letters
Spatially consistent random variables (SCRVs) have been used in many channel models to ensure a smooth time evolution and correlation of the channel coefficients among closely located terminals. However, most of the existing methods which generate SCRVs are restricted to mobility in the two-dimensional (2D) space and those that cover the three-dimensional (3D) space are still limited in terms of accuracy and/or complexity of processing and memory. This paper proposes a sum-of-sinusoids (SoS) method to generate a Gaussian process (GP) described by two different spatial autocorrelation functions (ACFs) considering single and dual mobility in the 3D space. The method was derived analytically for each of the considered ACFs and extends existing methods from the 2D to 3D space. Comparisons with existing baseline solution is carried out showing that the proposed method presents gains in terms of average squared error (ASE) up to 20 dB. Furthemore, the proposed method using only 100 coefficients presented an ASE around 10 dB smaller when compared with the baseline solution using 1000 coefficients.
15 July 2019 in Transactions on Emerging Telecommunications Technologies
25 February 2025 in IEEE Transactions on Vehicular Technology
This paper evaluates the network performance of a cellular system operating at 100 GHz with bandwidth of around 3 GHz under a dynamic transmission and reception point (TRP)- side discontinuous transmission (DTX) regime. The use of subterahertz (THz) bands is envisioned as a means to achieve higher data rates in sixth-generation (6G) systems. However, in this network setup, the power consumption at TRPs' radio components packed with several antenna elements significantly increases due to the very high processing burden in such a wide bandwidth. A TRP-side DTX method is proposed to avoid overheating issues, which controls the amount of downlink slot transmissions while guaranteeing cell-specific reference signaling. Simulation results considering different DTX settings and traffic loads are presented and discussed. Results show that the considered sub-THz system with the proposed DTX method can provide higher data rates and close to the same spectral efficiency compared to a typical baseline millimeter wave (mmWave) system operating at 28 GHz with 400 MHz bandwidth. It was possible to reach close to 7 times higher data rates in the simulated system utilizing the dynamic DTX method, compared to a theoretical data rate increase of 7.6 times based solely on bandwidth comparison.