Two new flavonoid glycosides, hypolaetin 4′-methyl ether 8-O-β-d-glucuronide 2″-sulfate (1) and hypolaetin 4′-methyl ether 3′-O-β-d-glucoside (2), and a new phenylpropanoid glucose ester, 1,6-diferuloyl glucose (3), were isolated from the leaves of Sterculia foetida L. Their structures were elucidated by spectroscopic analysis and chemical evidence.
Industrial wastewater contains diverse toxic dyes and drugs, which pollute the environment and poison creatures. Utilizing photocatalysts has been accepted to be an effective method to degrade water pollutions using solar light. Crystalline bismuth ferrite (Bi2Fe4O9) with a band gap of 1.9–2.0 eV is expected to be one of the most promising candidates for photocatalysts in the visible light region. Amorphous graphene is also a promising candidate as a photocatalyst owing to its excellent electronic and optical properties. Herein, a composite of Bi2Fe4O9/graphene aerogels (GAs) was prepared with a two-step hydrothermal method. The prepared Bi2Fe4O9 powders were confirmed to be successfully doped into GAs and evenly dispersed between graphene sheets. The Bi2Fe4O9/GA composite was utilized to perform photodegradation for organic dyes and antibiotic drugs under visible light irradiation, yielding efficiencies of 90.22%, 92.3%, 71.8% and 78.58% within 330 min for methyl orange, methylene blue, Rhodamine B and tetracycline hydrochloride, respectively. Such distinct photocatalytic activities overwhelmed the pure Bi2Fe4O9 powders of 14.10%, 22.19%, 13.98% and 48.08%, respectively. Additionally, the composite produced a degradation rate constant of 0.00623 min−1 for methylene blue, which is significantly faster than that of 0.00073 min−1 obtained by the pure powder. These results provide an innovative strategy for designing 3D visible-light-responsive photocatalysts combined with graphene aerogel for water purification.
10 November 2022 in Australian Journal of Chemistry
The layered Ti3C2 was successfully fabricated by etching the Al layer of Ti3AlC2 with the assistance of trifluoroacetic acid (TFA). By controlling the reaction time, the residual Ti3AlC2 phase in the Ti3C2 materials can be well removed by the TFA and the thickness of single Ti3C2 layer is ~10 nm. The absorption activity of the samples were also evaluated by adsorbing Congo red (CR) in the aqueous solution. The layered Ti3C2 exhibits much better absorption performance than that of pristine Ti3AlC2 and the maximum adsorption amount of CR is up to 351 mg g−1. This work develops a novel strategy to synthesize layered Ti3C2 without using the corrosive solvent.
A novel crystalline hexagonal prism g-C3N4 (HPCN) with fast photoelectron transfer along the (002) crystal facet is designed and exhibits superior photocatalytic hydrogen evolution performance and structural stability.