11 November 2010 in IEEE Transactions on Instrumentation and Measurement
This paper reports on the thermal Johnson-Nyquist noise of the quantum Hall and longitudinal resistances, which were measured both without an applied current and with an externally applied alternating or direct current. The results verify expected behavior and give interesting insights into the quantum Hall effect. They also demonstrate that ac measuring techniques commonly used in impedance metrology can take noise as a signal, reliably measuring tiny effects with a resolution of 10 pV.
17 April 2015 in IEEE Transactions on Instrumentation and Measurement
This paper describes the development of a compact n/8 inductive voltage divider (IVD) for the use in the frequency range between 1 and 100 kHz and voltages up to 5 V. The development includes a number of additional inductive components for the bootstrap calibration setup such as a supply transformer which ensures the galvanic isolation of the calibration setup, a calibration transformer, and a detection transformer. The desired frequency and uncertainty range requires a two-stage IVD design with coaxial windings, a triaxial differential branch, and voltage controlled shields to minimize capacitive stray currents. The bootstrap calibration setup follows a special coaxial-by-design scheme, which guarantees nearly identical currents in inner and outer conductors of the coaxial connections without use of any chokes. The calibration of the IVD yielded in-phase and quadrature IVD corrections within 6 · 10 -6 and 1 · 10 -6 both with uncertainties (k = 2) below 1 · 10 -6 at 100 kHz.
12 March 2007 in IEEE Transactions on Instrumentation and Measurement
This paper describes the setup and calibration of inductive bridge standards which realize selected voltage ratios—in particular, ratios between 0.1 and 1.3—at frequencies of a few tens of hertz with uncertainties from $1 \cdot 10^{-8}$ to $2 \cdot 10^{-8}\ (k = 2)$. With these bridge standards, ac thermometry bridges can be calibrated with the lowest possible uncertainties either manually or using computer control.