28 November 2017 in IEEE Transactions on Control Systems Technology
Selecting residual generators for detecting and isolating faults in a system is an important step when designing model-based diagnosis systems. However, finding a suitable set of residual generators to fulfill performance requirements is complicated by model uncertainties and measurement noise that have negative impact on fault detection performance. The main contribution is an algorithm for residual selection that combines model-based and data-driven methods to find a set of residual generators that maximizes fault detection and isolation performance. Based on the solution from the residual selection algorithm, a generalized diagnosis system design is proposed where test quantities are designed using multivariate residual information to improve detection performance. To illustrate the usefulness of the proposed residual selection algorithm, it is applied to find a set of residual generators to monitor the air path through an internal combustion engine.
1 January 2015 in IFAC-PapersOnLine
7 February 2022 in IET Conference Proceedings
Today's electric system is based on large power production units, that in addition to produce power also provides voltage and frequency control of the system. With the ongoing introduction of non-controllable distributed renewable energy production this is to change. This work investigates the potential of smart charging of electric vehicles and Vehicle-to-Grid (V2G) technology to stabilize the voltage in low voltage grids with high penetration of electric vehicles and photovoltaic systems. A low voltage grid from a suburban area with 29 households in a Swedish town and models of electric vehicles and photo-voltaic systems are used as a case study. Optimisation results show that simultaneous optimisation of charging trajectories for a subset of electric vehicles and V2G can significantly reduce voltage variations in the grid. Simultaneous optimisation of charging profiles is an alternative to upgrading the existing grid infrastructure to avoid large voltage variations, and is important to consider when, e.g., designing new price tariffs.
1 January 2022 in SSRN Electronic Journal
The rapid increase in electric vehicles, EV, and installed photovoltaic, PV, results in new challenges for the electric system, e.g., voltage stability in the low-voltage grids. The grid owner cannot directly control the power consumption of the end consumers. However, by the design of tariffs economic incentives are introduced for the end consumers to adjust the EV charging patterns. In this work, different tariffs are compared in different scenarios where the EV charging is optimized to minimize the overall electricity cost for the individual households. A model of an existing low-voltage grid, including PV and EV charging, and hourly data from household power consumption are used to simulate the voltage fluctuations based on the modified electric consumption. The different scenarios include, e.g., the use of vehicle to grid technology and different EV usage patterns, i.e., when the EV is connected to the charging station. The results show that a grid tariff including the maximum peak power is important for the grid voltage stability. Furthermore, if V2G technology is available, EVs are at home daytime, and PVs are installed, it is important to also minimize the maximum sold power from the households.