22 January 2020 in Scientific Reports
Vancomycin, a branched tricyclic glycosylated peptide antibiotic, is a last-line defence against serious infections caused by staphylococci, enterococci and other Gram-positive bacteria. Orally-administered vancomycin is the drug of choice to treat pseudomembranous enterocolitis in the gastrointestinal tract. However, the risk of vancomycin-resistant enterococcal infection or colonization is significantly associated with oral vancomycin. Using the powerful matrix-free assay of co-sedimentation analytical ultracentrifugation, reinforced by dynamic light scattering and environmental scanning electron microscopy, and with porcine mucin as the model mucin system, this is the first study to demonstrate strong interactions between vancomycin and gastric and intestinal mucins, resulting in very large aggregates and depletion of macromolecular mucin and occurring at concentrations relevant to oral dosing. In the case of another mucin which has a much lower degree of glycosylation (~60%) – bovine submaxillary mucin - a weaker but still demonstrable interaction is observed. Our demonstration - for the first time - of complexation/depletion interactions for model mucin systems with vancomycin provides the basis for further study on the implications of complexation on glycopeptide transit in humans, antibiotic bioavailability for target inhibition, in situ generation of resistance and future development strategies for absorption of the antibiotic across the mucus barrier.
7 October 2020 in npj Science of Food
Food flavour ingredients are required by law to obtain prior approval from regulatory bodies, such as the U.S. Food and Drug Administration (FDA) or the European Food Safety Authority (EFSA) in terms of toxicological data and intended use levels. However, there are no regulations for labelling the type and concentration of flavour additives on the product, primarily due to their low concentration in food and generally recognised as safe (GRAS) status determined by the flavour and extract manufacturers’ association (FEMA). Their status for use in e-cigarettes and other vaping products challenges these fundamental assumptions, because their concentration can be over ten-thousand times higher than in food, and the method of administration is through inhalation, which is currently not evaluated by the FEMA expert panel. This work provides a review of some common flavour ingredients used in food and vaping products, their product concentrations, inhalation toxicity and aroma interactions reported with different biological substrates. We have identified several studies, which suggest that the high concentrations of flavour through inhalation may pose a serious health threat, especially in terms of their cytotoxicity. As a result of the wide range of possible protein-aroma interactions reported in our diet and metabolism, including links to several non-communicable diseases, we suggest that it is instrumental to update current flavour- labelling regulations, and support new strategies of understanding the effects of flavour uptake on the digestive and respiratory systems, in order to prevent the onset of future non-communicable diseases.
11 April 2017 in Scientific Reports
VanA-type resistance to glycopeptide antibiotics in clinical enterococci is regulated by the VanSARAtwo-component signal transduction system. The nature of the molecular ligand that is recognised by the VanSAsensory component has not hitherto been identified. Here we employ purified, intact and active VanSAmembrane protein (henceforth referred to as VanS) in analytical ultracentrifugation experiments to study VanS oligomeric state and conformation in the absence and presence of vancomycin. A combination of sedimentation velocity and sedimentation equilibrium in the analytical ultracentrifuge (SEDFIT, SEDFIT-MSTAR and MULTISIG analysis) showed that VanS in the absence of the ligand is almost entirely monomeric (molar massM = 45.7 kDa) in dilute aqueous solution with a trace amount of high molar mass material (M ~ 200 kDa). The sedimentation coefficientssuggests the monomer adopts an extended conformation in aqueous solution with an equivalent aspect ratio of ~(12 ± 2). In the presence of vancomycin over a 33% increase in the sedimentation coefficient is observed with the appearance of additional higherscomponents, demonstrating an interaction, an observation consistent with our circular dichroism measurements. The two possible causes of this increase ins– either a ligand induced dimerization and/or compaction of the monomer are considered.
5 October 2017 in Scientific Reports
The reversibility and strength of the previously established dimerization of the important glycopeptide antibiotic vancomycin in four different aqueous solvents (including a medically-used formulation) have been studied using short-column sedimentation equilibrium in the analytical ultracentrifuge and model-independent SEDFIT-MSTAR analysis across a range of loading concentrations. The change in the weight average molar mass Mw with loading concentration was consistent with a monomer-dimer equilibrium. Overlap of data sets of point weight average molar masses Mw(r) versus local concentration c(r) for different loading concentrations demonstrated a completely reversible equilibrium process. At the clinical infusion concentration of 5 mg.mL−1 all glycopeptide is dimerized whilst at 19 µg.mL−1 (a clinical target trough serum concentration), vancomycin was mainly monomeric (<20% dimerized). Analysis of the variation of Mw with loading concentration revealed dissociation constants in the range 25-75 μM, commensurate with a relatively weak association. The effect of two-fold vancomycin (19 µg.mL−1) appears to have no effect on the monomeric enterococcal VanS kinase involved in glycopeptide resistance regulation. Therefore, the 30% increase in sedimentation coefficient of VanS on adding vancomycin observed previously is more likely to be due to a ligand-induced conformational change of VanS to a more compact form rather than a ligand-induced dimerization.
1 October 2019 in International Journal of Biological Macromolecules
To reduce animal testing, there is a need to develop novel in-vitro models for evaluating the retention of bioactive compounds in food and pharmaceutical products. Here, a mucus-mimetic platform was developed through a one-step approach based on encapsulating mucin within alginate gel beads. We found that mucins form micron sized aggregates distributed across the surface of the calcium-alginate bead, as shown by environmental scanning electron microscopy (ESEM). Retention of bioactive compounds on the mucin-functionalised surface was tested using a commercial orange drink formulation. To aid flavour retention, different mucoadhesive polymers with varying charge, including anionic, neutral and strongly cationic, were tested for their ability to interact with mucin and aid retaining flavour compounds within the mucin-alginate bead. The alginate-mucin mucus mimic was validated using an ex-vivo bovine tongue, with the flavour retention results showing qualitative agreement. The developed method proved to be a convenient, efficient tool for providing information on the effectiveness of mucoadhesive polymers without variability, safety and sustainability issues associated with an ex-vivo or in-vivo system. We propose that by encapsulating other relevant oral proteins, alongside mucins, current gaps between in-vitro and the ex-vivo systems may be narrowed.
1 October 2020 in Carbohydrate Polymers