8 February 2025 in Energy & Fuels
1 January 2026 in EES Batteries
Practical lithium-metal batteries (LMBs) will require optimized liqiud electrolyte formulations and Li reservoir to both minimize and replenish Li inventory, ensuring long system lifetime.
18 December 2024 in ChemRxiv
The design of new lithium-ion battery (LIB) cathode materials must balance many factors: performance, cost, manufacturability, safety, critical mineral usage and geopolitical constraints. Recently commercialised LiMnxFe1-xPO4 (LMFP) materials offer good energy density & stability, low material cost and excellent safety characteristics, avoiding the use of Co or Ni. Within this material set lies a wide variety of potential formulations (Mn/Fe ratio) exhibiting varied cathode properties and challenges. In this work, we assessed three commercially available LMFP materials with Mn content in the range 60 – 80 % in a full cell format, confirming the role of Mn/Fe ratio on specific capacity, energy density and electrochemical stability. High Mn content increased the average discharge voltage while maintaining specific discharge capacity, with 80 % Mn providing an 18 % boost to initial gravimetric energy density over LFP. However, worse kinetics and increased capacity fade rate resulted in the reduction and eventual elimination of this energy density advantage after 100 cycles. A blend cathode (LMFP and LiNi0.8Mn0.1Co0.1O2, NMC811) was also evaluated, exhibiting characteristics of both material types. An initial 23 % boost to energy density over LMFP alone was diluted following NMC-dominated degradation in early cycles, but enhanced capacity retention over NMC811 alone remained in long-term cycling. This work highlights the potential advantages of these newly commercialised materials, while identifying outstanding challenges to widespread adoption and exploitation.
17 September 2026 in PRX Energy
The fast cycling capability of Li-ion batteries is a key performance indicator for a range of applications including electric vehicles (EVs), in which systems must deliver/accept high currents while avoiding excessive degradation. We evaluate four leading EV battery chemistries in this context, encompassing cathodes focused on design-to-performance, LiNi 0.8 Mn 0.1 Co 0.1 O 2 (NMC811), and design-to-cost, LiMn 0.6 Fe 0.4 PO 4 (LMFP), alongside current state-of-the-art (graphite and graphite @ SiO x composite) and next-generation (high SiO x ) anodes. These chemistries are adopted as model systems to examine three common test protocols for evaluating fast cycling, specifically tuned to fast charge, fast discharge, or both. The capacity, degradation induced, and operational state-of-charge range were highly dependent on selected testing protocols. Significant loss of lithium inventory (LLI) was observed under fast-charging conditions, associated with lithium plating, observed via monitoring of anode potential in three-electrode cells, differential voltage analysis, and visual inspection of electrodes postmortem. LMFP cells induced a greater level of Li plating than NMC, reaching negative anode potentials in the early stages of fast charging. While the SiO x anode performed relatively well at high rates, it suffered a greater degree of degradation, including both LLI and impedance increase associated with excess SEI growth. This study provides a basis for battery material design and charging protocols tuned for fast cycling.