I. V. Moskalev

I. V. Moskalev

Auto-generated profile, based on publicly available information

I. V. Moskalev

Institute of Engineering Chemistry, Perm Federal Research Center, Ural Branch, Russian Academy of Sciences, Perm, Russia

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2014 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
IMI. V. Moskalev
I. V. Moskalev
TTT. G. Tiunova
T. G. Tiunova
DKD. M. Kisel’KOv
D. M. Kisel’KOv
APA. P. Petrovykh
A. P. Petrovykh
VVV. A. Val’TSifer
V. A. Val’TSifer
VSVladimir Strelnikov
Vladimir Strelnikov
The work reports results of investigations on the properties of pitches produced from the anthracene fraction of coal tar by means of the air-blowing and thermal cracking methods. For comparison, samples of coal tar pitch and air-blown pitches were used. The following parameters were determined: softening point, content of volatile matter, fractional and elemental compositions. In addition, thermal analysis and infra-red spectroscopy were performed. For cokes produced from the given pitches, the microstructure, porous structure and reactivity were analyzed. It was ascertained that pitches with cross-linked molecular structures formed during air-blowing of the anthracene fraction. These structures are characterized by low thermal stability—a feature that determines reduced coke residues of pitches and their elevated softening points, as well as the impossibility of forming the mesophase during coking, even for low viscosity and low contents of quinoline insolubles and toluene insolubles. Cokes produced from the air-blown anthracene fraction have a porous structure with high specific surface area. A porous structure and quinoline insolubles of the initial pitches lead to enhanced reactivity of producible cokes. During thermal cracking, i.e., under high temperatures and pressures, high-molecular condensed aromatic compounds are formed. These compounds determine the increased carbon content in pitches, the thermal stability of cokes, and the possibility of largesized mesophases forming, thus contributing to the formation of needle cokes. The thermal cracking process conditions the partial reactions of hydrocracking of heterocyclic compounds in the anthracene fraction; this leads to reduced contents of heteroatoms in producible pitches. While selecting pitches to obtain either isotropic or needle cokes, one should not be guided only by the softening point and contents of quinoline insolubles and toluene insolubles. A set of investigation methods and knowledge of the processing techniques and the nature of the initial raw materials are apparent prereqisites.

1 May 2014 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
IMI. V. Moskalev
I. V. Moskalev
DKDmitriy Kiselkov
Dmitriy Kiselkov
VSVladimir Strelnikov
Vladimir Strelnikov
VVViktor Valtsifer
Viktor Valtsifer
APA. P. Petrovykh
A. P. Petrovykh
NBN. Yu. Beilina
N. Yu. Beilina
The influence of the production conditions on the properties of coke is considered. Coke is produced in a pilot plant at the Institute of Technical Chemistry, Ural Branch, Russian Academy of Sciences, in a 200-L reactor equipped with an air-supply valve and heating elements. The first stage in coke production is air-blowing of the batch with constant temperature rise at 10–12°C/h from 290–310°C; the air flow rate is 45–55 L/kg h. At this stage, the final air-blowing temperature and the batch composition are varied. The second stage is coking, with temperature rise at 25°C/h to 550–600°C. The batch consists of industrial air-blown pitch (ABP), modified by pitch tar (PT). Oxidation of the ABP, even with a very high final temperature (434°C), does not permit the production of isotropic coke. An analogous result is obtained on adding small portions of PT to the batch (15%). On adding >50% PT, totally isotropic coke may be produced. To obtain coke of isotropic microstructure, the optimal content of PT is 36–41%, and the final air-blowing temperature should be high (>390°C). The influence of PT on the structural parameters of the coke is associated with the formation of nonmesogenic structures on air-blowing. On coking, these structures suppress the growth of large mesophase. The isotropic coke produced has the following characteristics: limited expansion in the range 1300–2400°C; high structural strength; and optimal density. Graphite based on such coke is considerably superior to graphite based on industrial pitch coke in terms of its compressive strength, density, and electrical resistivity.

1 March 2014 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
IMI. V. Moskalev
I. V. Moskalev
DKD. M. Kiselkov
D. M. Kiselkov
VSVladimir Strelnikov
Vladimir Strelnikov
VVViktor Valtsifer
Viktor Valtsifer
KLK. A. Lykova
K. A. Lykova
The properties of coke obtained by heat treatment of the anthracene fraction of coal tar under pressure (by thermocracking) are investigated. Pressures up to 5 MPa are used; the temperature is 500 or 550°C. For comparison, pitch coke is obtained from oxidized pitch with softening temperatures of 166.2 and 190.2°C. The coke yield from thermocracking is 70–75%. The following properties of the coke are determined: the actual density, the ash content, the yield of volatiles, the optical microstructure, the elementary composition, the change in volume on heating to 2400°C, the impurity composition, and the X-ray structural characteristics. High temperatures (at least 550°C) and heating rate of the anthracene fraction facilitate the formation of a large quantity of active radicals, which instantaneously form the three-dimensional coke structure, preventing the growth and coalescence of mesophase particles; isotropic coke is formed, with a microstructure score of 2.2. At 500°C, anisotropic coke is formed, with a microstructure score of 4.3. Despite the high softening temperature and the content of the α1 fraction, the high-temperature pitch does not form isotropic coke on carbonization. The macrostructure of the coke obtained by thermocracking is monolithic, with fine pores. The thermocracking conditions (temperature, pressure, presence of H2) facilitate partial destruction and hydrogenation of the heterocyclic compounds. As a result, the coke has a reduced N, S, and O content. For pitch coke, the nitrogen content is 20–40% higher. The lack of ash in the anthracene fraction of coal tar results in ash- and metal-free coke. The coke obtained by thermocracking also has satisfactory X-ray structural characteristics and undergoes practically no expansion on graphitization, in contrast to pitch coke. In view of the technological convenience (absence of liquid products, high coke yield) and the quality of the coke, the production of isotropic coke by thermocracking may be regarded as a promising means of supplying the raw material used to produce artificial graphite.

1 January 2015 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
APA. P. Petrovykh
A. P. Petrovykh
IMI. V. Moskalev
I. V. Moskalev
DKD. M. Kisel’KOv
D. M. Kisel’KOv
VVV. A. Val’TSifer
V. A. Val’TSifer
VSVladimir Strelnikov
Vladimir Strelnikov
The work reports results of investigations in how methods for modification of coal-tar pitches by means of air-blowing and of thermal treatment influence properties of producible air-blown pitches and microstructure of cokes based thereupon. Conditions under which air-blown pitches (ABP) were obtained: temperature varied from 300 to 370°C, 3 h duration of the process, the air flow rate about 100 L/kg h. Conditions of thermal treatment: temperature varied from 300 to 450°C, 3 h duration of the process. A sort of coal-tar pitch served as initial raw material. The ABP had the following parameters: softening point values from 117 to 190.2°C, content of toluene insolubles from 39.4 to 57.1%, content of quinoline insolubles from 10 to 48%. The thermally treated pitches (TTP) had the following parameters: softening point values from 86.2 to 264°C, content of toluene insolubles from 32.6 to 76%, content of quinoline insolubles from 6.2 to 70.7%. Comparison of two modification methods for pitches had evinced the air-blowing process to change properties of pitches at the same temperature to a larger extent as compared with thermal preparation. If temperature of thermal preparation exceeds temperature of air-blowing by 80–100°C, the softening point value for TTP samples is as near the same as that for the ABP samples. Samples of ABP have more high values of aromaticity index and of ortho-substitution index. Cokes based on ABP are capable of forming isotropic microstructure; at this point, their mean microstructure scores decrease from 3.8 to 2.7, as processing temperature rises. Cokes based on the TTP do not change their microstructure, as processing temperature varies; their mean microstructure score equals 4.2. This fact permits to classify the above mentioned cokes as regular cokes.

1 October 2020 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
IMI. V. Moskalev
I. V. Moskalev
DKD. M. Kisel’KOv
D. M. Kisel’KOv
AAA. L. Abaturov
A. L. Abaturov
The thermal oxidation of mixtures of moderate-temperature coal pitch and the anthracene fraction of coal tar is investigated. The microstructure of the cok

1 November 2018 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
AAA. L. Abaturov
A. L. Abaturov
IMI. V. Moskalev
I. V. Moskalev
DKDmitriy Kiselkov
Dmitriy Kiselkov
VSVladimir Strelnikov
Vladimir Strelnikov
Attention focuses on how the thermal oxidation of hydrocarbon mixtures by air injection at elevated temperatures affects the microstructure of the isotropic coke formed on subsequent...