20 July 2023 in Chemical Engineering Journal
13 March 2023 in Journal of Chemical Technology & Biotechnology
BACKGROUND: The anode material of bioelectrochemical systems (BES) is crucial because its characteristics directly affect electron transfer from the bacteria to the anode. To assess its usefulness, each material must undergo evaluation under relevant operating conditions, as well as a complete electrochemical characterization.RESULTS: Five carbonaceous materials – carbon brush (CB), carbon granules (CG), thicker carbon felt (CF1), high‐conductivity carbon felt (CF2), and high‐active‐area carbon felt (CF3) – anodes were tested in this work. The current generation with each anode material was studied, operating as a microbial fuel cell (MFC) and microbial electrolysis cell (MEC). Two MFC inoculation strategies were tested: (i) fixed 10 Ω external resistance (ER) and (ii) poised anode potential (PA) of 200 mV versus Ag/AgCl. Once reproducible cycles were obtained in MFC operation, CB yielded the highest maximum current density, amounting to 15.9 A m−2. A slightly reduced start‐up time was observed for each anode with PA than ER. When the anodes were transferred to MEC operation, the maximum hydrogen production rate of 1.04 m3 H2 m−3 d−1 was obtained for CB.CONCLUSION: This study helps in selecting anode material for BES, allowing a shortening of the start‐up time and improving its performance using different inoculation strategies and anode materials. Among all the anode materials employed in this study, CB and CF3 electrodes presented the best overall performance. © 2023 The Authors. Journal of Chemical Technology and Biotechnology published by John Wiley & Sons Ltd on behalf of Society of Chemical Industry (SCI).
3 June 2025 in Bioelectrochemistry
Bioelectrochemical systems enable the recovery of ammonium from wastewater with low energy requirements and as a concentrated nitrogen-rich stream. This work aims to thoroughly investigate different cathodic electrode configurations and to optimize the operational conditions for active ammonium recovery from synthetic wastewater as concentrated ammonium sulphate. Different applied current intensities (50 mA, corresponding to 5 A m-2, and 75 mA, corresponding to 7.5 A m-2) and initial ammonium concentrations (between 0.3 and 3 g L-1 N-NH4+) were tested in an abiotic electrochemical system to understand the upper threshold of the used three-chamber configuration with hydrophobic membrane in terms of ammonium recovery rate (Rrec). With an external current of 75 mA, the highest value was 55 gN-NH4+ m-2 d-1 when removing 97 % from an initial ammonium concentration of 3 g L-1. Bioelectrochemical ammonium removal/recovery was evaluated under different applied potentials (0.8, 1.0, 1.2, and 1.4 V) using two configurations: a Nickel-based gas diffusion electrode (GDE) and a configuration with the cathode (stainless steel or nickel foam) physically separated from the hydrophobic membrane. The highest removal rate (Rrem) (21 gN-NH4+ m-2 d-1) was exhibited for stainless steel cathode at 1.4 V mainly due to its higher current density, which increased the cations migration. This higher Rrem also led to a higher Rrec (17 gN-NH4+ m-2 d-1).
29 December 2025 in Chemical Engineering Journal