9 December 2022 in Revista UIS Ingenierías
Although AISI 304 steel is widely used and its manufacturers provide resistance data in the quality certificate, these are not sufficient to characterize and predict the behavior of the sheets in the drawing and drawing processes. This is why the objective of this work was to analyze the formability of AISI 304 steel sheets with 16- (thickness 1.5 mm), 18- (1.2 mm), and 20- (0.9 mm) gauges used by the metalworking industry in Colombia by determining intrinsic properties related to the ability of the sheet to withstand stretching and drawing operations such as the strain hardening exponent n, the normal anisotropy rm, and the planar anisotropy Δr. The methodology consisted of analyzing the chemical composition, a metallographic study, and a series of tensile tests. The results show that the steel has a microstructure of twinned austenite grains of size between 15-30 mm. Regarding the mechanical resistance, it was observed that all the mean values of ultimate resistance, elastic limit, and elongation are above the minimum established in the standard. Furthermore, all of the tensile test results changed according to the variation of angles concerning the rolling direction (0°, 45°, and 90°), which indicates the anisotropic character of the sheet. The most relevant result allows us to infer that the 20-gauge sheet has better formability and therefore, better behavior against the stretching and drawing processes.
26 June 2023 in INGENIERÍA Y COMPETITIVIDAD
La formabilidad es una propiedad importante en láminas metálicas sometidas a procesos de estirado y embutido. Una manera de medirla es a través de las curvas límite de formabilidad (CLF), que permiten determinar los límites de resistencia del material en este tipo de operaciones. En este trabajo se presenta la construcción de curvas límite de formabilidad para 3 chapas de acero inoxidable AISI 304, con espesores de 0.9, 1.2 y 1.5 milímetros, utilizadas en el sector metalmecánico colombiano. Para ello, se realizaron ensayos simulativos bajo lo establecido en la norma ASTM E2218, mediante un dispositivo de embutido acoplado a una máquina universal. Se realizaron las curvas en los rangos de deformación verdadera ε1 (entre 0 y 0,8) y ε 2 (entre -0,4 y 0,3). Los puntos más bajos de cada curva que marcan la condición de deformación plana (FLD0) fueron: Para 0.9 mm (0,01 de ε_2 y 0,45 de ε_1), para 1.2 mm (0,01 de ε_2 y 0,38 de ε_1) y para 1.5 mm (0,02 de ε_2 y 0,40 de ε_1). La curva para el espesor de 0.9 mm mostró mejor comportamiento que las de 1.5 y 1.2 mm respectivamente, y coincide con los mayores resultados obtenidos por la misma chapa en propiedades intrínsecas como el alargamiento total εt, el exponente de endurecimiento por deformación n y el valor de la anisotropía planar Δr.