13 December 2013 in Environmental Science & Technology
23 April 2012 in Aerosol Science and Technology
Aqueous hydroxyl radical (∼10−12 M) oxidation of glycolaldehyde (1 mM), followed by droplet evaporation, forms secondary organic aerosol (SOA) that exhibits an effective liquid vapor pressure and enthalpy of vaporization of ∼10−7 atm and ∼70 kJ/mol, respectively, similar to the mix of organic acids identified in reaction samples. Salts of these acids have vapor pressures about three orders of magnitude lower (e.g., ammonium succinate ∼10−11 atm), suggesting that the gas–particle partitioning behavior of glycolaldehyde SOA depends strongly on whether products are present in the atmosphere as acids or salts. Several reaction samples were used to simulate cloud droplet evaporation using a vibrating orifice aerosol generator. Samples were also analyzed by ion chromatography (IC), electrospray ionization mass spectrometry (ESI-MS), IC-ESI-MS, and for total carbon. Glycolaldehyde SOA mass yields were 50–120%, somewhat higher than yields reported previously (40–60%). Possible reasons are discussed: (1) formation of oligomers from droplet evaporation, (2) inclusion of unquantified products formed by aqueous photooxidation, (3) differences in gas–particle partitioning, and (4) water retention in dried particles. These and similar results help to explain the enrichment of organic acids in particulate organic matter above clouds compared with those found below clouds, as observed previously in aircraft campaigns. Copyright 2012 American Association for Aerosol Research
3 February 2017 in Journal of Applied Physics
Exothermic reactions between oxophilic metals and transition/post transition metal-oxides have been well documented owing to their fast reaction time scales (≈10 μs). This article examines the extent of the reaction in nano-aluminum based thermite systems through a forensic inspection of the products formed during reaction. Three nanothermite systems (Al/CuO, Al/Bi2O3, and Al/WO3) were selected owing to their diverse combustion characteristics, thereby providing sufficient generality and breadth to the analysis. Microgram quantities of the sample were coated onto a fine platinum wire, which was resistively heated at high heating rates (≈105 K/s) to ignite the sample. The subsequent products were captured/quenched very rapidly (≈500 μs) in order to preserve the chemistry/morphology during initiation and subsequent reaction and were quantitatively analyzed using electron microscopy and focused ion beam cross-sectioning followed by energy dispersive X-ray spectroscopy. Elemental examination of the cross-section of the quenched particles shows that oxygen is predominantly localized in the regions containing aluminum, implying the occurrence of the redox reaction. The Al/CuO system, which has simultaneous gaseous oxygen release and ignition (TIgnition ≈ TOxygen Release), shows a substantially lower oxygen content within the product particles as opposed to Al/Bi2O3 and Al/WO3 thermites, which are postulated to undergo a condensed phase reaction (TIgnition ≪ TOxygen Release). An effective Al:O composition for the interior section was obtained for all the mixtures, with the smaller particles generally showing a higher oxygen content than the larger ones. The observed results were further corroborated with the reaction temperature, obtained using a high-speed spectro-pyrometer, and bomb calorimetry conducted on larger samples (≈15 mg). The results suggest that thermites that produce sufficient amounts of gaseous products generate smaller product particles and achieve higher extents of completion.
4 March 2019 in Journal of Geophysical Research: Atmospheres
We have determined optical properties of heterogeneous particles from aerosol samples collected at Hawaii's Mauna Loa Observatory. Back trajectories, satellite imagery, and composition differences among particles from scanning electron microscopy revealed a subset of particles with dolomite or calcite that likely came from Asia. Using focused ion‐beam tomography and the discrete dipole approximation, we show how small amounts of an iron phase (oxide or carbonate), or in one case soot, affected extinction and scattering compared with particles of neat dolomite or calcite. We show how particles exhibit a range scattering values due to varying orientations of the inclusion phases. Extinction efficiencies for the heterogeneous particles with dolomite (3.47) and calcite (3.36) were 19% to 21% lower than extinction for marine background air particles (3.72). Extinction for the Asian dust was, however, generally higher than for the neat particles. Compared to iron carbonate, the presence of an absorbing iron oxide affected scattering in Asian dust particles even at the low oxide concentrations studied here (0.6% to 8.1%). Scattering efficiency decreased by <1% with a 1% increase in hematite but by 2% to 5% with magnetite. Asian dust scattered light strongly forward, but backscattering was 56% larger than for the marine background air particles. Backscattering in the Asian dust was also larger with magnetite than hematite. Single scattering albedo for Asian dust with hematite, magnetite, or soot averaged 0.96 ± 0.06 ( ) but was as low as 0.72 with a magnetite mass of 5.8%.
30 January 2018 in Atmospheric Chemistry and Physics
Isoprene oxidation produces water-soluble organic gases capable of partitioning to aerosol liquid water. The formation of secondary organic aerosols through such aqueous pathways (aqSOA) can take place either reversibly or irreversibly; however, the split between these fractions in the atmosphere is highly uncertain. The aim of this study was to characterize the reversibility of aqSOA formed from isoprene at a location in the eastern United States under substantial influence from both anthropogenic and biogenic emissions. The reversible and irreversible uptake of water-soluble organic gases to aerosol water was characterized in Baltimore, Maryland, USA, using measurements of particulate water-soluble organic carbon (WSOCp) in alternating dry and ambient configurations. WSOCp evaporation with drying was observed systematically throughout the late spring and summer, indicating reversible aqSOA formation during these times. We show through time lag analyses that WSOCp concentrations, including the WSOCp that evaporates with drying, peak 6 to 11 h after isoprene concentrations, with maxima at a time lag of 9 h. The absolute reversible aqSOA concentrations, as well as the relative amount of reversible aqSOA, increased with decreasing NOx ∕ isoprene ratios, suggesting that isoprene epoxydiol (IEPOX) or other low-NOx oxidation products may be responsible for these effects. The observed relationships with NOx and isoprene suggest that this process occurs widely in the atmosphere, and is likely more important in other locations characterized by higher isoprene and/or lower NOx levels. This work underscores the importance of accounting for both reversible and irreversible uptake of isoprene oxidation products to aqueous particles.
1 April 2016 in Atmospheric Environment