1 October 2019 in Physics of Fluids
Laser induced cavitation is one of the effective techniques to generate controlled cavitation bubbles, both for basic study and for applications in different fields of engineering and medicine. Unfortunately, control of bubble formation and symmetry is hardly achieved due to a series of concurrent causes. In particular, the need to focus the laser beam at the bubble formation spot leads, in general, to a conical region proximal to the light source where conditions are met for plasma breakdown. A finite sized region then exists where the electric field may fluctuate depending on several disturbing agents, leading to possible plasma fragmentation and plasma intensity variation. Such irregularities may induce asymmetry in the successive bubble dynamics, a mostly undesired effect if reproducible conditions are sought for. In the present paper, the structure of the breakdown plasma and the ensuing bubble dynamics are analyzed by means of high speed imaging and intensity measurements of the shockwave system launched at breakdown. It is found that the parameters of the system can be tuned to optimize repeatability and sphericity. In particular, symmetric rebound dynamics is achieved almost deterministically when a pointlike plasma is generated at the breakdown threshold energy. Spherical symmetry is also favored by a large focusing angle combined with a relatively large pulse energy, a process which, however, retains a significant level of stochasticity. Outside these special conditions, the elongated and often fragmented conical plasma shape is found to be correlated with anisotropic and multiple breakdown shockwave emission.
1 October 2020 in Experimental Thermal and Fluid Science
12 May 2015 in Experiments in Fluids
1 May 2017 in The Journal of the Acoustical Society of America
Aim of this paper is the identification of uncorrelated forces acting on a structure based on a coherence analysis of the structure response, performed entirely in operative condition. In order to identify the position and the amplitude of the applied load only the responses of the structure and the experimental FRF are required. The proposed procedure consists of three steps. First, the number of acting loads is established by the analysis of the responses coherence, second the position of the acting forces is identified using an index obtained by the knowledge of experimental FRF and of the responses of the structure, then, the amplitude of the acting forces is computed in correspondence of the excited points. The procedure is tested by two experiments. First experiment consists in the excitation of a complex structure in several places with an instrumented hammer. The identification is performed by the accelerations measured on a set of points of the structure itself. The second experiment is carried out by exciting a structure with a fluid flow in a wind tunnel. The accelerations of the structure vibrations and the structure-born acoustic noise are measured and used to identify the fluid pressure acting on the structure.