1 January 2020 in Advances in Materials Science and Engineering
To analyze the fractal characteristics of coal rock failure under unloading conditions, triaxial unloading confining pressure tests were carried out on coal and sandstone rock samples under different unloading rates and initial confining pressures. We examined the distribution of the surface cracks and fragmentation of the coal and sandstone samples that failed under different triaxial unloading confining pressure tests. The results showed that the fractal dimension of the surface cracks in coal and sandstone decreased as the initial unloading confining pressure increased. Thus, shear failure is more obvious in coal or sandstone with high‐stress conditions caused by unloading confining pressure than in coal or sandstone with low‐stress conditions. However, the fractal dimension of the surface cracks increased with the unloading rates. Additionally, the fractal dimension of the fragmentation in the coal and sandstone samples had a negative correlation with the initial unloading confining pressure. When the initial confining pressure was relatively low, the samples underwent splitting and shear failure; when the initial confining pressure was higher, the failure mode was mostly shear failure and the fragmentation of the samples was less homogeneous. In contrast, the fractal dimension of the fragmentation in the coal and sandstone increased with higher unloading rates. The lithology had a significant effect on the fractal dimension of the surface cracks and on the fragmentation. Samples with more internal fissures had more surface cracks and the fragmentation was more homogeneous when the rock failed compared with samples with less fissures under the same experimental conditions.
1 December 2024 in Physics of Fluids
As an efficacious medium for enhancing oil recovery, CO2 has been extensively employed in the domain of petroleum extraction and can effectively improve the oil recovery rate to a certain extent. However, the mechanisms of oil–gas distribution and migration in low-permeability reservoirs remain unclear and require further study. The development of nuclear magnetic resonance (NMR) testing provides a new method for visualizing displacement experiments. This research investigates CO2 displacement and NMR testing on low-permeability cores, simultaneously focusing on multiple controlling factors such as injection pressure, temperature, core permeability, and CO2 phase state. Cores were selected based on NMR assessments of pore-permeability characteristics, followed by four sets of displacement experiments. Results show that injection pressure and core permeability are the primary factors influencing oil recovery. High injection pressure can enhance oil recovery and effective recovery occurs when pressure exceeds the threshold (about 6 MPa for core #3 in this study), with recovery rates above 30%. Low-permeability cores do not form effective displacement channels, while high-permeability cores, especially those with fractures, are prone to CO2 breakthrough, reducing recovery efficiency, such as core #6. During low-pressure recovery, there is a discernible migration of oil from smaller to larger pores before extraction, totally differing from the pattern observed in high-pressure recovery. Additionally, temperature increases were found to improve recovery slightly, but the impact of CO2 phase on recovery remains inconclusive due to the limitation of the equipment and need further discussion.