Laura Pérez-Martínez

Laura Pérez-Martínez

Auto-generated profile, based on publicly available information

Laura Pérez-Martínez

School of Natural and Computing Sciences, University of Aberdeen 1 , Aberdeen AB24 3UE Scotland, United Kingdom

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2023 in The Journal of Chemical Physics
Verified
Journal Article
Open access
PDF file
LPLaura Pérez-Martínez
Laura Pérez-Martínez
Enrique HerreroEnrique Herrero
Enrique Herrero
ACAngel Cuesta
Angel Cuesta
The potential dependence of the rate of dehydration of formic acid to adsorbed CO (COad) on Pt at pH 1 has been studied on a polycrystalline Pt surface by time-resolved surface-enhanced infrared absorption spectroscopy in the attenuated total reflection mode (ATR-SEIRAS) with simultaneous recording of current transients after a potential step. A range of formic acid concentrations has been used to obtain a deeper insight into the mechanism of the reaction. Our experiments have allowed us to confirm that the potential dependence of the rate of dehydration has a bell shape, going through a maximum around the potential of zero total charge (pztc) of the most active site. The analysis of the integrated intensity and frequency of the bands corresponding to COL and COB/M shows a progressive population of the active sites on the surface. The observed potential dependence of the rate of formation of COad is consistent with a mechanism in which the reversible electroadsorption of HCOOad is followed by its rate-determining reduction to COad.

28 October 2026 in Electrochimica Acta
Verified
Journal Article
Closed access
DCDavide Cademartori
Davide Cademartori
KRKandela Ruiz
Kandela Ruiz
VTVioleta Ureña Torres
Violeta Ureña Torres
AAAlba Acevedo
Alba Acevedo
LPLaura Pérez-Martínez
Laura Pérez-Martínez
IGIñigo Garbayo
Iñigo Garbayo

23 October 2026 in Journal of the Electrochemical Society
Verified
Journal Article
Closed access
VTVioleta Ureña Torres
Violeta Ureña Torres
PCPaula Ciaurriz
Paula Ciaurriz
YBYuli Betancur
Yuli Betancur
AAAlba Acevedo
Alba Acevedo
LPLaura Pérez-Martínez
Laura Pérez-Martínez
IGIñigo Garbayo
Iñigo Garbayo
The scale-up of solid oxide cells (SOCs) manufacturing is critical for its industrial implementation. However, it presents significant challenges, including obtaining defect-free, dimensionally uniform layers and reproducible microstructure, controlling slurry properties, and minimizing resource consumption and waste generation. This work details the successful transition of a half-cell fabrication route (Ni-YSZ/YSZ) from laboratory scale to a pre-industrial roll-to-roll system, representing one of the first demonstrations of water-based multilayer casting at this scale. The scale-up was performed using water-based slurries as a feasible alternative to conventional organic-based systems, by carefully adjusting both slurry preparation and deposition parameters (i.e. gap, casting speed and drying temperature). While implementing pre-industrial fabrication, reduced slurry viscosity, sample reproducibility and appropriate microstructure were observed, resulting in maintained electrochemical performance (0.38 ± 0.02 and 0.42 ± 0.04 W cm −2 , using LSM-YSZ oxygen electrode). In addition, the optimized multilayer deposition resulted in fivefold increase in production capacity, from ∼ 30 to > 150 half-cells per week, as well as cost-efficient material utilization (from 3.5 to 0.7 € material cost per half-cell). These findings demonstrate the feasibility of high-throughput water-based SOCs manufacturing by a more sustainable process and offer a pathway toward the cost-effective production of next-generation energy technologies.