27 July 2024 in Journal of Computer Assisted Learning
Background: Flying accuracy is influenced by pilots' affective reactions to task demands. A better understanding of task‐related emotions and flying performance is needed to enhance pilot training. Objective: Understand pilot trainees' performance and emotional dynamics (intensity, frequency and variability) based on training phase and difficulty level in a flight simulator. Methods: Twenty‐three volunteers performed basic flight manoeuvres. Trials were divided into three phases: Introduction (trials 1–7), session A (trials 8–15) and session B (trials 16–22). Three task difficulty levels were implemented (low, medium and high). Flying performance was evaluated using root mean square error (RMSE) and expert ratings. Emotional intensity was inferred from physiological (electrodermal activity) and behavioural (facial expressions) emotional responses. Emotional variability was calculated to understand fluctuations among multiple emotions. Emotional responses were mapped into task‐relevant emotions, like sadness with boredom, and fear with anxiety. Results and Conclusions: The most frequent facial expressions neutral, anger and surprise. Neutral and anger were interpreted as deep focus states. Surprise was likely a response to unexpected events. Flying performance and emotional dynamics varied across training phases and difficulty levels. During introduction, performance was less accurate, and emotions were less frequent. During session A, performance improved while participants experienced more physiological arousal and emotional variability. During session B, performance was the most accurate. In high‐difficulty tasks, performance was the least accurate, participants expressed emotions with more frequency, more variability and higher physiological arousal. Future studies can use simulated flying tasks for trainees to familiarize with their emotional reactions to task demands expecting to improve training outcomes.
1 September 2005 in Proceedings of the Human Factors and Ergonomics Society Annual Meeting
DQD. Thorndycraft Qinetiq
This paper describes an investigation of a workload measurement technique based on pilot control movements. The Dynamic Interface Modeling and Simulation System Product Metric (DIMSS PM) assumes that pilot control activity can be used to evaluate pilot workload. Three qualified test pilots flew the fly-bywire NRC Bell 205 helicopter in a short test program that compared the DIMSS PM with subjective workload ratings and handling qualities ratings. The pilots performed a variation of an ADS-33E bob-up with varying levels of simulated turbulence and modified cyclic control characteristics. Good agreement was found for most in-flight test conditions between DIMSS Workload Metric scores and subjective workload ratings from the Bedford Workload Scale and Cooper-Harper handling qualities ratings. While, the DIMSS Workload Metric did not accurately reflect workload increases due to variations in the cyclic stick characteristics, the metric shows promise as an objective measurement tool of pilot workload in well-defined tests.
1 January 2021 in Journal of the American Helicopter Society
Rotorcraft symbology can provide pilots with the flight information necessary to replace the visual cues lost when operating in degraded visual environments. However, tuning symbology for effective use is a time-consuming process as it generally requires considerable in-flight testing and extensive trial and error. In this work, two experiments are conducted to assess how changes in the display scaling of a position–velocity–acceleration architectured symbology set affects pilot performance and workload. In the first experiment, participants attempt a modified single-axis precision hover using a simulated helicopter and nonconformal symbology set while display parameters relating to acceleration, velocity, and position cue scaling are varied. Performance is measured using the root mean square of the position error relative to a target location, and participant workload is assessed using their cyclic control activity and Bedford ratings. In the second experiment, an analytical pilot-in-the-loop simulation is conducted to validate the performance results obtained in the first experiment and to investigate the underlying system characteristics that contribute the observed trends. For the implemented symbology and Bell UH-1H model, the results from both experiments concur that a combination of low-to-mid range acceleration cue scaling and mid-to-high range position cue scaling enable strong performance without inflating workload. Results indicate an insensitivity to velocity vector scaling, likely due to the symbology architecture and nature of the control task. The results of these experiments establish a predictable relationship between display scaling and pilot response, which can aid in streamlining the tuning process for similarly-styled symbology, helicopter and task envelope combinations.