Although the cone penetration test (CPT) is essential for geotechnical design, it is often not economically feasible and time-consuming to perform the tests at all sites. This work used data from Port Sudan City to create a model to predict CPT values from Standard Penetration Test (SPT) attributes using a Support Vector Regression (SVR) algorithm. This approach converted the SPT into attribute combinations through a stepwise regression analysis. Subsequently, the attributes were converted to CPT by training the SVR neural network with the available CPT data. Cross-validation was performed to assess the credibility of the SPT parameters in the CPT transformation. In this procedure, a quarter of the data set is omitted from the training set each time, and the transformation is recalculated. Next, the accuracy of the transformation in estimating CPT from the deleted data is evaluated; this procedure is applied to all data in the training set. The results show that comparing the actual and predicted CPT gives a good agreement, as indicated by high correlation coefficient values for the training and test data sets. This approach can be used for automated estimation of CPT from SPT parameters and can serve as an extension of conventional techniques.
Liquefaction is one of the most critical ground deformations in saturated or partially saturated silty and sandy soils. This deformation may cause severe destruction, such as settlement and building tilting. A standard penetration test (SPT) is commonly used to estimate liquefaction potential. This study integrates SPT, unit weight, and fine content data measurements from 24 boreholes in Port Sudan to evaluate and identify the liquefaction potential and factor of safety (F.S.) in earthquake scenarios. The liquefaction parameters were derived according to the simplified procedure in this scope. The result showed that the subsurface soil up to 15 meters is saturated with grain sizes varying from medium to fine sand, silt, and clay. Based on calculated parameters and fine content, the area falls within the high risk of liquefaction by a 7.5 (Mw) earthquake. The F.S. is mainly less than one in the upper 15 m. The liquefaction potential index is assessed using a peak horizontal ground acceleration of 0.15 g for an earthquake scenario of magnitude 7.5. The proposed approach proved to be a rapid and reliable method for investigating the liquefaction of sandy soil under earthquakes.