8 May 2019 in Nature Communications
Metal-halide perovskites have been widely investigated in the photovoltaic sector due to their promising optoelectronic properties and inexpensive fabrication techniques based on solution processing. Here we report the development of inorganic CsPbBr3-based photoanodes for direct photoelectrochemical oxygen evolution from aqueous electrolytes. We use a commercial thermal graphite sheet and a mesoporous carbon scaffold to encapsulate CsPbBr3 as an inexpensive and efficient protection strategy. We achieve a record stability of 30 h in aqueous electrolyte under constant simulated solar illumination, with currents above 2 mA cm−2 at 1.23 VRHE. We further demonstrate the versatility of our approach by grafting a molecular Ir-based water oxidation catalyst on the electrolyte-facing surface of the sealing graphite sheet, which cathodically shifts the onset potential of the composite photoanode due to accelerated charge transfer. These results suggest an efficient route to develop stable halide perovskite based electrodes for photoelectrochemical solar fuel generation.
20 November 2020 in ACS Applied Energy Materials
29 July 2019 in Journal of Materials Chemistry A
TiO 2 photoanodes with {0 1 0} facets exposed show high photoelectrochemical performance and IPCE of 100% at 350 nm.
26 February 2019 in ACS Applied Energy Materials
Depositing an oxygen evolution electrocatalyst on the intricate pores of semiconductor light-absorbing layers of photoanodes for photoelectrochemical solar water splitting is an efficient way to improve their performance, but it adds extra costs and difficulties. In this work, we present a synthesis of hematite (-Fe2O3) photoanodes with a self-derived conductive amorphous FeOx electrocatalyst coating. Hematite-FeOx photoanodes were prepared via FeOOH precursors modified with low levels of lactic acid additive. In absence of lactic acid, FeOOH consisted of lepidocrocite nanorods that resulted in -Fe2O3 particulate photoanodes with sharp crystal edges upon doctor blading and calcination. Lactic acid addition however resulted in goethite and amorphous FeOOH that formed -Fe2O3 particulate photoanodes coated by a thin conductive amorphous FeOx layer. Electron microscopies revealed the thickness of this layer was controlled with the addition of lactic acid in the preparation. Photoelectrochemical characterization including Tafel plots, impedance spectroscopy, hole scavenger measurements and confirmed the FeOx layer behaved as an FeOOH electrocatalyst, enhancing charge transfer efficiency and minimizing electron-hole surface recombination. Such coating increased the electrochemically-active surface area and amount of surface states. Photocurrent increased from 0.32 to 1.39 mA cm-2 at 1.23 VRHE under simulated sunlight, remarkable results for an auto-co-catalyzed and simple solution-process deposition.
19 September 2018 in Sustainable Energy & Fuels
[Ti4Mo2O8(OEt)10]2cages were used for the formation of Mo-doped TiO2photoanodes with better performance than pure TiO2.