Biomass discharged from primary industries can be converted into methane by fermentation. This methane is used for generating electricity with solid oxide fuel cells (SOFCs). This methane fermentation provides H2S, which reduces the efficiency of SOFCs even at a level as low as a few parts per million. It has been experimentally reported that a nitrogen (N)-doped graphene-based material known as pyridinic N removes H2S via an oxidation reaction compared with another graphene-based material known as oxidized N. To understand this experimental result, we investigated H2S adsorption on pyridinic N and oxidized N by a density functional theory analysis and further examined the activation barrier of dissociation reactions. We found that the adsorption of H2S on pyridinic N is more stable than that on oxidized N. In addition, the H2S dissociation reaction occurs only on pyridinic N.
This research develops a stable, high-performance electrocatalyst with an electron-rich interface between modified MXene and nitrogen-doped nickel molybdenum oxide, enabling efficient high-current operation while suppressing chlorine evolution.
4 April 2026 in Results in Surfaces and Interfaces
The reliability of a biogas-fueled SOFC depends directly on the purity of the biogas. To prevent performance degradation caused by H2S poisoning, this study aimed to develop a nitrogen (N)-doped carbon derived from biomass feedstock using the digested liquid as the N source, which acted as an adsorbent material to reduce the H2S concentration in biogas to below the sub-ppm level. Biochar (BC) derived from rice husk (RH) treated with 25 vol% NH3 gas (balanced with N2) at 900°C for 120 min, RH-BC(N900-120), exhibited the largest H2S breakthrough capacity (APCH2S(0)) of 8.02 mg H2S g-BC−1 and a total H2S adsorption capacity (ACPH2S) of 9.58 mg H2S g-BC−1. The largest ACPH2S, 23.0 mg H2S g-BC−1, was obtained for the RH-BC treated with NH3 evaporated from a 10 wt% NH3 solution (simulating a concentrated digested liquid) at 850°C for 270 min, RH-BC(EN850-270), with an APCH2S(0)of 3.96 mg H2S g-BC−1. For a strongly N-doped BC such as RH-BC(N900-120), the formation of surface sulfate after H2S adsorption was more significant compared to a mildly N-doped BC, i.e. RH-BC(EN850-270), in which the interaction of the surface with H2S was moderately weakened, preventing the blockage of micropore openings by the accumulation of sulfate. Consequently, the H2S molecules could be adsorbed into the micropores, resulting in a higher ACPH2S.
26 October 2024 in Physical Chemistry Chemical Physics