14 June 2017 in IEEE Transactions on Vehicular Technology
In ambient rescatter communications, devices convey information by modulating and rescattering the radio frequency signals impinging on their antennas. In this correspondence, we consider a system consisting of a legacy modulated continuous carrier multiple-input-multiple-output link and a multiantenna modulated rescatter (MRS) node, where the MRS node modulates and rescatters the signal generated by the legacy transmitter. The receiver seeks to decode both the original message and the information added by the MRS. We show that the achievable sum rate of this system exceeds that which the legacy system could achieve alone. We further consider the impact of channel estimation errors under the least squares channel estimation and study the achievable rate of the legacy and MRS systems, where a linear minimum mean square error receiver with successive interference cancellation is utilized for joint decoding.
11 May 2021 in IEEE Internet of Things Journal
Ambient backscatter communication (AmBC) is an emerging communication technology enabling green Internet of Things deployments. The widespread acceptance of this paradigm is limited by the low signal-to-interference-plus-noise ratio (SINR) of the signal impinging on the receiver antenna due to the strong direct path interference and unknown ambient signal. The adverse impact of these two factors can be mitigated by using noncoherent multiantenna receivers, which are known to require a higher SINR to reach the bit-error-rate (BER) performance of coherent receivers. However, considering the unknown ambient signal, unknown location of AmBC tags, and varying channel conditions, coherent receivers for AmBC systems are rarely studied in the literature. In this article, a coherent multiantenna receiver, which requires no prior information of the ambient signal for decoding the binary-phase-shift-keying (BPSK) modulated signal, is presented. The performance of the proposed receiver is compared with an ideal coherent receiver that has perfect phase information, and also with the performance of a noncoherent receiver, which assumes distributions for ambient signal and phase offset caused by the excess length of the backscatter path. Comparative simulation results show the designed receiver can achieve the same BER performance of the ideal coherent receiver with 1-dB more SINR, which corresponds to 5-dB or more gain with respect to noncoherent reception of on-off-keying modulated signals. Variation in the detection performance with the tag location shows that the coverage area is in the close vicinity of the transmitter and a larger region around the receiver, which is consistent with the theoretical results.
2 December 2020 in IEEE Access
In Ambient Backscatter Communications (AmBC), a backscatter device communicates by modulating the ambient radio frequency (RF) signal impinging at its antenna. In many cases, the system setup is bi-static such that the receiver and the ambient signal source are separated in space. This configuration suffers from the direct path interference problem. The direct signal component can be several orders of magnitude stronger than the scattered one. This imposes a challenge for the receiver that needs to have high dynamic range in order not to lose the scattered signal component to the quantization noise. In this paper, we propose a novel AmBC system concept, in which a polarization conversion between the direct and scattered path is introduced at the backscatter device and exploited at the dual polarization based receiver antenna to mitigate the direct path interference. The proposed system is agnostic to the ambient signal source characteristics as long as it uses linearly polarized antennas. The backscatter device changes the polarization from linear to circular. The receiver antenna is a circularly polarized patch antenna with a 180-hybrid to obtain the difference between the left-and right-hand polarized fields. Ideally, this receiver antenna and 180-hybrid combination would completely remove linearly polarized direct path and reflected components. In this paper, we propose a robust design that can mitigate the direct path signal power more than 25 dB despite nonidealities in the antenna manufacturing.
14 October 2021 in IEEE Wireless Communications Letters
In this letter, we investigate the multi-bounce effect on the performance of multi-tag monostatic backscatter communication systems with multi-antenna reader. We derive a channel model for the considered system setup and propose a minimum mean square error receiver followed by a sequential demodulation to decode the backscattered information from the tags. A tight lower bound on the achievable sum rate is derived and the asymptotic analysis demonstrates the effect the different system parameters on the performance. It is shown that with proper receiver design, the multi-bounce effect can play an important role in improving the sum-rate performance especially at low signal to noise ratio regime.
1 January 2019 in IEEE Access
28 May 2013 in Conference Papers in Engineering
In this study, the maximum achievable information transmission rate of spectrum sharing cognitive radio with maximal ratio combining (MRC) antenna diversity technique is investigated when the channel between the secondary transmitter and the primary receiver and that between the secondary transmitter and the secondary receiver suffer Nakagami-m fading. With an assumption that both channels encounter Nakagami-m fading and the transmission of the secondary transmitter is subject to average interference power constraint, the approximated expressions for analyzing the effective capacity and the ergodic capacity of cognitive radio users with MRC are presented. The two capacity models are compared. In the case of the effective capacity, it is shown that different applications or users with different quality of service (QoS) requirements can be supported in cognitive radio, and when the delay QoS decreases, the effective capacity approaches the ergodic capacity.