A low power wireless sensor network based on LoRaWAN protocol was designed with a focus on the IoT low-cost Precision Agriculture applications, such as greenhouse sensing and actuation. All subsystems used in this research are designed by using commercial components and free or open-source software libraries. The whole system was implemented to demonstrate the feasibility of a modular system built with cheap off-the-shelf components, including sensors. The experimental outputs were collected and stored in a database managed by a virtual machine running in a cloud service. The collected data can be visualized in real time by the user with a graphical interface. The reliability of the whole system was proven during a continued experiment with two natural soils, Loamy Sand and Silty Loam. Regarding soil parameters, the system performance has been compared with that of a reference sensor from Sentek. Measurements highlighted a good agreement for the temperature within the supposed accuracy of the adopted sensors and a non-constant sensitivity for the low-cost volumetric water contents (VWC) sensor. Finally, for the low-cost VWC sensor we implemented a novel procedure to optimize the parameters of the non-linear fitting equation correlating its analog voltage output with the reference VWC.
20 October 2007 in Sensors and Actuators B: Chemical
Drain-source current in organic thin-film transistors has been monitored in situ and in real time during the deposition of pentacene. The current starts to flow when percolation of the first monolayer (ML) occurs and, depending on the deposition rate, saturates at a coverage in the range 2–7 MLs. The number of active layers contributing to the current and the spatial distribution of charge carriers are modulated by the growth mode. The thickness of the accumulation layer, represented by an effective Debye length, scales as the morphological correlation length. These results show that the effective Debye length is not just a material parameter, but depends on the multiscale morphology. Earlier controversial results can be unified within this framework.
The rapid development and wide application of the IoT (Internet of Things) has pushed toward the improvement of current practices in greenhouse technology and agriculture in general, through automation and informatization. The experimental and accurate determination of soil moisture is a matter of great importance in different scientific fields, such as agronomy, soil physics, geology, hydraulics, and soil mechanics. This paper focuses on the experimental characterization of a commercial low-cost “capacitive” coplanar soil moisture sensor that can be housed in distributed nodes for IoT applications. It is shown that at least for a well-defined type of soil with a constant solid matter to volume ratio, this type of capacitive sensor yields a reliable relationship between output voltage and gravimetric water content.
The activation energy of electromigration in 'bamboo'-type, passivated Al-1% Si/TiN/Ti lines was determined by means of high resolution resistance measurements at wafer level. Both the very early stages, with a nonlinear behaviour of the resistance, and the subsequent stages, characterized by an approximately constant rate of resistance change, were analysed with an existing model that correlates electromigration and mechanical stress evolution. An activation energy could be extracted only in the phase of linear resistance increase, where a value of 0.95 eV was found. Diffusion at the interface between Al-Si and the barrier metal or the passivation could be responsible for this value of the activation energy.