24 February 2021 in IEEE Transactions on Antennas and Propagation
Conformal antennas are practicable candidates to the aerodynamic platforms. A wide-angle scanning conformal phased array antenna for an unmanned aerial vehicle (UAV) platform is designed and presented in this article. An eight-element linear phased array loaded with frequency selective surface (FSS) operating in S-band is investigated. The horizontally polarized antenna element is designed based on a tapered slot feeding dipole. The antenna aperture can be easily conformed to the front wing airframe of the UAV due to the flexibility of the employed polyimide film. To fulfill the requirement of the airborne communication system, two kinds of FSSs are loaded on the dipole antenna to enhance the gain and reduce the 3 dB beamwidth of the main lobe in the elevation plane. To improve the active impedance matching when the beam scans to the large angles, a novel parasitic structure is proposed. Finally, a 1 ×8 linear conformal array prototype is simulated, fabricated, and measured. The experimental results indicate that the antenna array achieves a fractional bandwidth of 22.1% with ±70° scanning along the E-plane. The measured results validate the performance of the proposed conformal array and the design.
23 July 2020 in IEEE Antennas and Wireless Propagation Letters
Polyimide film is a practicable alternative to the conventional substrates utilized in conformal antennas. Due to its flexibility, the antennas based on polyimide film can be easily conformed to the platform surface. An 8-element linear phased array operating at P band with wide scan angle is investigated in this letter, which is constructed by the dipoles printed on polyimide film. The antenna surface is mounted on the front wing of an unmanned aerial vehicle (UAV). Strong coupling is observed between array elements when the beam scans. Therefore, decoupling structures are loaded in the array elements to broaden the scan angle. To satisfy the requirement of the radar system, directors and reflectors are also employed on the surface of the front wing to narrow main lobe beamwidth in the elevation plane. The proposed phased array achieves a fractional bandwidth of 16.7% when scanning up to 60 in the E-plane. The validity of this design is verified by simulation and measurements of a 18 array prototype.
30 September 2019 in IEEE Transactions on Antennas and Propagation
Indium tin oxide (ITO) material is a practicable alternative to metal utilized in transparent antennas. However, the conductor loss of ITO material is the major obstacle to antenna design. In this work, an optically transparent reflectarray based on glass substrate with ITO film operating at 28 GHz is presented. A novel sub-wavelength element operating in hybrid modes with 0.167λ0 (λ0 is the free-space wavelength at 28GHz) spacing is proposed for transparent reflectarray design. The peak loss of the proposed element is below 3.4 dB and a phase variation of 420° is achieved at 28 GHz. A 54×54-element reflectarray with a focus to diameter ratio (F/D) of 0.7 is designed and simulated for demonstration. It achieves radiation efficiency higher than 73% at the center operating frequency. The proposed reflectarray is verified by the measurements, which is reasonably consistent with the full-wave simulated results.