Mattia Didone

Mattia Didone

Auto-generated profile, based on publicly available information

Mattia Didone

Department of Mechanical Engineering Technical University of Denmark Kgs. Lyngby Denmark

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 February 2017 in Packaging Technology and Science
Verified
Journal Article
Closed access
PDF file
MDMattia Didone
Mattia Didone
Prateek SaxenaPrateek Saxena
Prateek Saxena
EBEllen Brilhuis‐Meijer
Ellen Brilhuis‐Meijer
GTGuido Tosello
Guido Tosello
Giuliano BissaccoGiuliano Bissacco
Giuliano Bissacco
THThomas J. Howard
Thomas J. Howard

17 September 2018 in Packaging Technology and Science
Verified
Journal Article
Closed access
PDF file
MDMattia Didone
Mattia Didone
GTGuido Tosello
Guido Tosello

16 August 2019 in Drying Technology
Verified
Journal Article
Closed access
MDMattia Didone
Mattia Didone
SMSankhya Mohanty
Sankhya Mohanty
JHJesper Hattel
Jesper Hattel
MSMads Sonne
Mads Sonne
EElisabetta Maria Fiordaliso
Elisabetta Maria Fiordaliso
GUIDO TOSELLOGUIDO TOSELLO
GUIDO TOSELLO
Molded pulp products are experiencing increased importance due to their environment-friendly characteristics with regards to both production and disposal. In this study, the thermoforming process for the production of molded pulp products was examined by means of two experimental campaigns, with the scope of distinguishing between the water removal due to only compression (better known as cold pressing) and the water removal under additional thermal conditions. The underlying multiphysics of the processes were identified by comparison with similar manufacturing processes found in available literature, and then implemented using a 1-dimensional finite element model in COMSOL software. This fast, simple model was able to predict the water removal for a specific set of process conditions and the results were supported by corresponding experimental observations. Within a process time of up to 15 s, temperatures ranging from 80 °C to 120 °C, and a final dryness between 40% and 65%, the simulations gave accurate estimates, with a difference in prediction down to 0.3%. The paper thus documents the first combined experimental-simulation study for thermoforming of molded pulp products.

27 October 2020 in Packaging Technology and Science
Verified
Journal Article
Open access
PDF file
MDMattia Didone
Mattia Didone
GTGuido Tosello
Guido Tosello
For an effective optimization of pulp thermoforming and of the moulded pulp products manufactured by this process, a full understanding of the process physics combined with full knowledge of the pressing equipment is necessary. For this reason, in this Addendum, we clarify how the process parameters “Holding time,” “Vacuum time,” “Cycle time,” and “Temperature” were interpreted and subsequently defined for the analysis of the process and product‐related outputs of the thermoforming experiments.