19 September 2024 in Nature Nanotechnology
Manganese-based materials have tremendous potential to become the next-generation lithium-ion cathode as they are Earth abundant, low cost and stable. Here we show how the mobility of manganese cations can be used to obtain a unique nanosized microstructure in large-particle-sized cathode materials with enhanced electrochemical properties. By combining atomic-resolution scanning transmission electron microscopy, four-dimensional scanning electron nanodiffraction and in situ X-ray diffraction, we show that when a partially delithiated, high-manganese-content, disordered rocksalt cathode is slightly heated, it forms a nanomosaic of partially ordered spinel domains of 3–7 nm in size, which impinge on each other at antiphase boundaries. The short coherence length of these domains removes the detrimental two-phase lithiation reaction present near 3 V in a regular spinel and turns it into a solid solution. This nanodomain structure enables good rate performance and delivers 200 mAh g−1 discharge capacity in a (partially) disordered material with an average primary particle size of ∼5 µm. The work not only expands the synthesis strategies available for developing high-performance Earth-abundant manganese-based cathodes but also offers structural insights into the ability to nanoengineer spinel-like phases.
6 May 2025 in Advanced Materials
To address the growing demand for energy and support the shift toward transportation electrification and intermittent renewable energy, there is an urgent need for low‐cost, energy‐dense electrical storage. Research on Li‐ion electrode materials has predominantly focused on ordered materials with well‐defined lithium diffusion channels, limiting cathode design to resource‐constrained Ni‐ and Co‐based oxides and lower‐energy polyanion compounds. Recently, disordered rocksalts with lithium excess (DRX) have demonstrated high capacity and energy density when lithium excess and/or local ordering allow statistical percolation of lithium sites through the structure. This cation disorder can be induced by high temperature synthesis or mechanochemical synthesis methods for a broad range of compositions. DRX oxides and oxyfluorides containing Earth‐abundant transition metals have been prepared using various synthesis routes, including solid‐state, molten‐salt, and sol‐gel reactions. This review outlines DRX design principles and explains the effect of synthesis conditions on cation disorder and short‐range cation ordering (SRO), which determines the cycling stability and rate capability. In addition, strategies to enhance Li transport and capacity retention with Mn‐rich DRX possessing partial spinel‐like ordering are discussed. Finally, the review considers the optimization of carbon and electrolyte in DRX materials and addresses key challenges and opportunities for commercializing DRX cathodes.
23 December 2024 in Advanced Materials
Mn‐rich disordered rocksalt materials with Li‐excess (DRX) materials have emerged as a promising class of earth‐abundant and energy‐dense next‐generation cathode materials for lithium‐ion batteries. Recently, an electrochemical transformation to a spinel‐like “δ” phase has been reported in Mn‐rich DRX materials, with improved capacity, rate capability, and cycling stability compared with previous DRX compositions. However, this transformation unfolds slowly over the course of cycling, complicating the development and understanding of these materials. In this work, it is reported that the transformation of Mn‐rich DRX materials to the promising δ phase can be promoted to occur much more rapidly by electrochemical pulsing at elevated temperature, rate, and voltage. To extend this concept, micron‐sized single‐crystal DRX particles are also transformed to the δ phase by the same method, possessing greatly improved cycling stability in the first demonstration of cycling for large, single‐crystal DRX particles. To shed light on the formation and specific structure of the δ phase, X‐ray diffraction, scanning electron nanodiffraction (SEND) and atomic resolution STEM‐HAADF are used to reveal a nanodomain spinel structure with minimal remnant disorder.
24 June 2024 in Chemistry of Materials
In situ carbon dioxide (CO2) outgassing is a common phenomenon in lithium-ion batteries (LiBs), primarily due to parasitic side reactions at the cathode-electrolyte interface. However, little is known about the chemical origins of the in situ CO2 released from emerging Li-excess cation-disordered rock salt (DRX) cathodes. In this study, we selectively labeled various carbon sources with 13C in cathodes containing a representative DRX material, Li1.2Mn0.4Ti0.4O2 (LMTO), and performed differential electrochemical mass spectrometry (DEMS) during galvanostatic cycling in a carbonate-based electrolyte. When charging LMTO cathodes, electrolyte solvent (EC) decomposition is the dominant source of the CO2 outgassing. The amount of EC-originated CO2 is strongly correlated with the total surface area of carbon black in the electrode, revealing the critical role of electron-conducting carbon additives in the electrolyte degradation mechanisms. In addition, unusual bimodal CO2 evolution during the first cycle is found to originate from carbon black oxidation. Overall, the underlying chemical origin of in situ CO2 release during battery cycling is highly voltage- and cycle-dependent. This work further provides insights into improving the stability of DRX cathodes in LiBs and is envisioned to help guide future relevant material design to mitigate parasitic reactions in DRX-based batteries.
16 June 2025 in Advanced Energy Materials
Li‐excess disordered rocksalts (DRXs) hold promise as next‐generation cathodes for Li‐ion batteries due to their high capacity and energy density, along with the potential to eliminate the need for Co and Ni. However, due to their low Li+ diffusivity, DRXs need to be pulverized into nanoparticles to achieve high performance. Herein, a new strategy for overcoming this limitation is demonstrated, involving the design of as‐synthesized partially disordered oxides with a structure that lies between ordered layered and fully disordered, exhibiting a varying degree of local (dis)order. This unique structure activates new Li+ diffusion channels, improving percolation and transport properties. This strategy allows a large content of Li+ to be accessed in material with large, micron‐sized particles through highly reversible Cr3+/6+ and O redox, yielding a first discharge capacity of 286 mAh g−1 (881 Wh kg−1). The Li+ percolation network is further improved by substituting Ti with a mixture of multiple metals, which appears to locally decrease the migration barrier through lattice distortion. Proper tuning of the chemical composition, especially the content of metals with empty d orbitals, is established as a crucial factor for controlling the degree of disorder and mitigating voltage fade and hysteresis growth upon cycling.
6 August 2026 in Advanced Energy Materials
With the increasing demand for Li‐ion batteries, the reliance on nickel (Ni) and cobalt (Co) has become a critical concern given the high cost and scarcity of these resources. The recently discovered Mn‐rich disordered rocksalt (DRX) oxides have demonstrated high energy density and capacity retention, positioning them as promising candidates for low‐cost sustainable energy storage materials. These Mn‐rich DRX materials undergo structural transformation into a partial spinel‐like ordering phase (δ) during electrochemical cycling, thereby enhancing the rate capability and capacity retention. In this work, δ is formed by delithiation and heating, which bypasses the need for long cycling to form δ. In addition, we identify the correlation between the degree of transformation and the delithiation level and heating time.