Art McGarr

Art McGarr

Auto-generated profile, based on publicly available information

Art McGarr

U.S. Geological Survey

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 January 2014 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
AMA. McGarr
A. McGarr
Analysis of numerous case histories of earthquake sequences induced by fluid injection at depth reveals that the maximum magnitude appears to be limited according to the total volume of fluid injected. Similarly, the maximum seismic moment seems to have an upper bound proportional to the total volume of injected fluid. Activities involving fluid injection include (1) hydraulic fracturing of shale formations or coal seams to extract gas and oil, (2) disposal of wastewater from these gas and oil activities by injection into deep aquifers, and (3) the development of enhanced geothermal systems by injecting water into hot, low-permeability rock. Of these three operations, wastewater disposal is observed to be associated with the largest earthquakes, with maximum magnitudes sometimes exceeding 5. To estimate the maximum earthquake that could be induced by a given fluid injection project, the rock mass is assumed to be fully saturated, brittle, to respond to injection with a sequence of earthquakes localized to the region weakened by the pore pressure increase of the injection operation and to have a Gutenberg-Richter magnitude distribution with a b value of 1. If these assumptions correctly describe the circumstances of the largest earthquake, then the maximum seismic moment is limited to the volume of injected liquid times the modulus of rigidity. Observations from the available case histories of earthquakes induced by fluid injection are consistent with this bound on seismic moment. In view of the uncertainties in this analysis, however, this should not be regarded as an absolute physical limit.

20 February 2015 in Science
Verified
Journal Article
Closed access
PDF file
AMA. McGarr
A. McGarr
BBB. Bekins
B. Bekins
NBN. Burkardt
N. Burkardt
JDJ. Dewey
J. Dewey
PEP. Earle
P. Earle
ASA. Sheehan
A. Sheehan
Large areas of the United States long considered geologically stable with little or no detected seismicity have recently become seismically active. The increase in earthquake activity began in the mid-continent starting in 2001 (1) and has continued to rise. In 2014, the rate of occurrence of earthquakes with magnitudes (M) of 3 and greater in Oklahoma exceeded that in California (see the figure). This elevated activity includes larger earthquakes, several with M > 5, that have caused significant damage (2, 3). To a large extent, the increasing rate of earthquakes in the mid-continent is due to fluid-injection activities used in modern energy production (1, 4, 5). We explore potential avenues for mitigating effects of induced seismicity. Although the United States is our focus here, Canada, China, the UK, and others confront similar problems associated with oil and gas production, whereas quakes induced by geothermal activities affect Switzerland, Germany, and others.

5 June 2018 in Geophysical Research Letters
Verified
Journal Article
Open access
PDF file
AMA. McGarr
A. McGarr
ABAndrew J. Barbour
Andrew J. Barbour
The cumulative seismic moment is a robust measure of the earthquake response to fluid injection for injection volumes ranging from 3,100 to about 12 million m3. Over this range, the moment release is limited to twice the product of the shear modulus and the volume of injected fluid. This relation also applies at the much smaller injection volumes of the field experiment in France reported by Guglielmi et al. (2015, https://doi.org/10.1126/science.aab0476) and laboratory experiments to simulate hydraulic fracturing described by Goodfellow et al. (2015, https://doi.org/10.1002/2015GL063093). In both of these studies, the relevant moment release for comparison with the fluid injection was aseismic and consistent with the scaling that applies to the much larger volumes associated with injection‐induced earthquakes with magnitudes extending up to 5.8. Neither the microearthquakes, at the site in France, nor the acoustic emission in the laboratory samples contributed significantly to the deformation due to fluid injection.

28 September 2017 in Geophysical Research Letters
Verified
Journal Article
Open access
PDF file
AMA. McGarr
A. McGarr
ABAndrew J. Barbour
Andrew J. Barbour
Each of the three earthquake sequences in Oklahoma in 2016—Fairview, Pawnee, and Cushing—appears to have been induced by high‐volume wastewater disposal within 10 km. The Fairview M5.1 main shock was part of a 2 year sequence of more than 150 events of M3, or greater; the main shock accounted for about half of the total moment. The foreshocks and aftershocks of the M5.8 Pawnee earthquake were too small and too few to contribute significantly to the cumulative moment; instead, nearly all of the moment induced by wastewater injection was focused on the main shock. The M5.0 Cushing event is part of a sequence that includes 48 earthquakes of M3, or greater, that are mostly foreshocks. The cumulative moment for each of the three sequences during 2016, as well as that for the 2011 Prague, Oklahoma, and nine other sequences representing a broad range of injected volume, are all limited by the total volumes of wastewater injected locally.

1 January 2016
Verified
Report
Closed access
PDF file
MPMark D. Petersen
Mark D. Petersen
CMCharles S. Mueller
Charles S. Mueller
MMMorgan P. Moschetti
Morgan P. Moschetti
SHSusan M. Hoover
Susan M. Hoover
ALAndrea L. Llenos
Andrea L. Llenos
KRKenneth S. Rukstales
Kenneth S. Rukstales
The U.S. Geological Survey (USGS) has produced a 1-year seismic hazard forecast for 2016 for the Central and Eastern United States (CEUS) that includes contributions from both induced and natural earthquakes. The model assumes that earthquake rates calculated from several different time windows will remain relatively stationary and can be used to forecast earthquake hazard and damage intensity for the year 2016. This assessment is the first step in developing an operational earthquake forecast for the CEUS, and the analysis could be revised with updated seismicity and model parameters. Consensus input models consider alternative earthquake catalog durations, smoothing parameters, maximum magnitudes, and ground motion estimates, and represent uncertainties in earthquake occurrence and diversity of opinion in the science community. Ground shaking seismic hazard for 1-percent probability of exceedance in 1 year reaches 0.6 g (as a fraction of standard gravity [g]) in northern Oklahoma and southern Kansas, and about 0.2 g in the Raton Basin of Colorado and New Mexico, in central Arkansas, and in north-central Texas near Dallas. Near some areas of active induced earthquakes, hazard is higher than in the 2014 USGS National Seismic Hazard Model (NHSM) by more than a factor of 3; the 2014 NHSM did not consider induced earthquakes. In some areas, previously observed induced earthquakes have stopped, so the seismic hazard reverts back to the 2014 NSHM. Increased seismic activity, whether defined as induced or natural, produces high hazard. Conversion of ground shaking to seismic intensity indicates that some places in Oklahoma, Kansas, Colorado, New Mexico, Texas, and Arkansas may experience damage if the induced seismicity continues unabated. The chance of having Modified Mercalli Intensity (MMI) VI or greater (damaging earthquake shaking) is 5–12 percent per year in north-central Oklahoma and southern Kansas, similar to the chance of damage caused by natural earthquakes at sites in parts of California.

1 January 2015
Verified
Report
Closed access
MPMark D. Petersen
Mark D. Petersen
CMCharles S. Mueller
Charles S. Mueller
MMMorgan P. Moschetti
Morgan P. Moschetti
SHSusan M. Hoover
Susan M. Hoover
JRJustin L. Rubinstein
Justin L. Rubinstein
JAJohn G. Anderson
John G. Anderson