Superconducting magnetic bearings are becoming more widespread, due to the unique properties they provide. Their efficiency is unparallel, there are no issues such as contact, friction, and wear. They require low or minimal maintenance, no lubrication and they work under extreme conditions (cryogenic temperatures, high vacuum). In this contribution, the influence of geometric properties of superconducting bulks on the performance of superconducting bearings was studied. The main focus was paid to load capacity, radial and axial stiffnesses. Two samples with a significantly higher aspect ratio compared to conventional bulks were prepared. One of these samples was synthesized with artificially created holes. The samples were prepared using top-seeded melt-growth process with an additional source of a liquid phase in the form of an underlaying pad. The original thickness of 16 mm of the samples with a diameter of 28 mm was repeatedly ground down. Levitation force and trapped field were measured after each grinding step. Using this approach, the dependence of properties of the bulks on their thickness, scaling of these properties with thickness and the influence that artificial holes can make on the properties of finished single domain bulks were studied. The maximum levitation force was greatly improved for bulks with thicknesses of 2–6 mm. Such data is of the utmost importance in the field of superconducting YBCO single domain bulk ceramics, as it allows for better understanding and further improvement of both the manufacturing process and real-world applications of these materials.
In this contribution, glycerol–water based nanofluids were developed as medium-temperature heat transfer and thermal energy storage fluids suitable for household and small industrial applications. Nanofluids containing stabilized SiO₂, Al₂O₃, and Cu nanoparticles (0.86–1.0 wt%) were prepared using a simple, cost-effective mixing approach with gum arabic as a surfactant. The systems were characterized with respect to dispersion stability, stored thermal energy, viscosity, and thermal conductivity. Comparative medium-scale calorimetric measurements demonstrated a consistent enhancement of stored thermal energy by approximately 2–7% relative to the glycerol–water reference, despite the expected decrease predicted by the rule of mixtures. Thermal conductivity increased from 0.347 W·m⁻¹·K⁻¹ for the reference fluid to 0.354–0.360 W·m⁻¹·K⁻¹ for the nanofluids, with the highest improvement observed for copper-containing systems. Dynamic viscosity remained practically unchanged at room temperature (23–29 mPa·s) and showed only a moderate increase at 70 °C, remaining well within acceptable limits for heat transfer applications. Structural and spectroscopic analyses (SEM, HR-TEM, XRD, FTIR) confirmed nanoparticle stability during thermal cycling and indicated interfacial interactions between nanoparticles and the glycerol matrix, which likely contribute to the observed thermal enhancement. These results demonstrate that glycerol-based nanofluids with affordable oxide or metal nanoparticles represent a viable, environmentally friendly alternative to conventional medium-temperature heat transfer fluids.