Objective: The objective of this study was to measure the forces and moments exerted by direct printed aligners (DPAs) with varying facial and lingual aligner surface thicknesses, in all three planes of space, during lingual movement of a maxillary central incisor. Materials and methods: An in vitro experimental setup was used to quantify forces and moments experienced by a programmed tooth to be moved and by adjacent anchor teeth, during lingual movement of a maxillary central incisor. DPAs were directly 3D-printed with Tera Harz TC-85 (Graphy Inc., Seoul, South Korea) clear photocurable resin in 100-µm layers. Three multi-axis sensors were used to measure the moments and forces generated by 0.50 mm thick DPAs modified with labial and lingual surface thicknesses of 1.00 mm in selective locations. The sensors were connected to three maxillary incisors (the upper left central, the upper right central, and the upper left lateral incisors) during 0.50 mm of programmed lingual bodily movement of the upper left central incisor. Moment-to-force ratios were calculated for all three incisors. Aligners were benchtop tested in a temperature-controlled chamber at intra-oral temperature to simulate intra-oral conditions. Results: The results showed that increased facial thickness of DPAs slightly reduced force levels on the upper left central incisor compared to DPAs of uniform thickness of 0.50 mm. Additionally, increasing the lingual thickness of adjacent teeth reduced force and moment side effects on the adjacent teeth. DPAs can produce moment-to-force ratios indicative of controlled tipping. Conclusions: Targeted increases in thickness of direct 3D-printed aligners change the magnitude of forces and moments generated, albeit in complex patterns that are difficult to predict. The ability to vary labiolingual thicknesses of DPAs is promising to optimize the prescribed orthodontic movements while minimizing unwanted tooth movements, thereby increasing the predictability of tooth movements.
1 December 2021 in American Journal of Orthodontics and Dentofacial Orthopedics
Objective: To measure enamel thickness at the proximal surfaces of the mandibular incisors, using micro-computed tomography (micro-CT) scans. Material and Methods: Forty-one single-rooted mandibular incisors were selected and analyzed according to anatomical characteristics, to form three groups: Group 1 - central incisors (n = 18); Group 2 - right lateral incisors (n = 10); and Group 3 - left lateral incisors (n = 13). First, enamel thickness at the proximal contact areas of the mandibular incisors was measured. Second, the mesial and distal surfaces of the lateral incisors were compared. Finally, the relationship between the tooth width and the mean enamel thickness was determined. Each tooth was scanned with a micro-CT scanner, and the image was processed with SCANCO micro-CT onboard analysis software. Results: There were no statistically significant differences in mean enamel thickness between the mesial and distal surfaces for each lateral incisor, or between contralateral lateral incisors. In all surfaces analyzed, the upper zones had statistically significantly thinner enamel (0.52 ± 0.10 mm) when compared to the middle and lower zones (0.60 ± 0.08 mm and 0.59 ± 0.08 mm, respectively). There was no correlation (r =0.07) between enamel thickness of the mandibular incisor and the tooth width. Conclusions: The enamel thickness of the mandibular incisors is similar on the mesial and distal surfaces, with the thinnest layer located at the upper zone.