1 October 2023 in Physics of Fluids
The distribution of matrix pressure and water saturation during the fracturing and shut-in period significantly impacts shale gas production. However, traditional numerical simulations primarily focus on the production period, often overlooking the impact of fracturing and shut-in on the seepage field and production rates. This study uses the dual-porosity/dual-permeability-embedded discrete fracture model (DPDK-EDFM) to characterize matrix mixed wettability and the natural/hydraulic fracture geometry. A multiscale numerical simulation model is constructed to encompass the whole life cycle of shale fracturing, shut-in, and production. The model provides a comprehensive understanding for considering the changes in rock properties and the diverse migration mechanisms. Subsequently, the life cycle model is used for sensitivity analysis on capillary pressure, shut-in time, and fracturing fluid volume. The findings demonstrate that (1) capillary pressure strongly impacts flowback rate. As surface tension increases from 0 to 72 mN/m, the flowback rate decreases from 113.00% to 68.25%. (2) The shut-in time strongly affects the uniformity of pressure distribution. (3) The fracturing fluid volume is directly proportional to the rise in formation pressure. This innovative model provides a robust framework for simulating and analyzing the seepage field behavior of shale gas reservoirs throughout the life cycle. Furthermore, through a comprehensive investigation of the main controlling factors, this study provides valuable insights into the efficient development of shale gas reservoirs, carrying both theoretical and practical significance.
1 March 2025 in Petroleum Science
1 October 2025 in International Journal of Heat and Mass Transfer
17 June 2022 in Frontiers in Energy Research
The permeability interpretation accuracy of single wells in the Middle East super-thick carbonate reservoir can hardly meet the actual demand of water injection development. Therefore, this study develops an iterative split algorithm to calculate single-well segmental dynamic permeability and SPI (specific production index) based on the dynamic and static well test, PLT (production log test), production test, and logging interpretation data. Moreover, the dynamic permeability classification evaluation index was optimized. The detailed steps are as follows: 1) The liquid supply of a single well is split according to tp PLT. 2) For some production intervals, the log interpretation data are applied to carry out the second iteration splitting of formation coefficient and fluid supply. 3) The proportion of liquid supply in the stratification section is calculated based on the calculation results of steps 1 and step 2. 4) The total formation coefficient of well test interpretation is divided based on the calculation results of step 3. 5) The dynamic permeability and SPI are calculated. The research results show that the dynamic permeability and SPI of a single well are accurate to the scale of one meter from the several original meters to tens of meters, which can better meet the needs of water injection development. In addition, SPI can be used as an essential index for permeability classification evaluation. Taking the Halfaya Oilfield and the Mishrif format reservoir as examples, the low penetration rate of the MB1-2 high penetration rate is 200md and the lower specific production index limit is 0.35 bbl/(d·m·psi), respectively. The dynamic foundation of the high-permeability layer is identified. This method offers a new idea for the title of high-permeability streaks. Moreover, this method can provide the scientific basis for correcting the permeability attribute model, water injection plan optimization, single-well completion cementing scheme, and water coning control, which can be popularized and applied in the same reservoirs.