24 April 2019 in Vehicle System Dynamics
In the development of heavy-duty vehicles, the design of hydro-pneumatic suspension (HPS) is important for improving various aspects of vehicle performance, such as comfort and stability. An HPS with gas–oil emulsion is advantageous with respect to cost and design compared to that with a separated chamber, because it shares a chamber with gas and oil. This paper presents an optimisation procedure for obtaining the optimal design of HPS with gas–oil emulsion for heavy-duty vehicles. The HPS model is developed from a mathematical analysis of the gas–oil emulsion, and a parameter study is performed to confirm the design sensitivity of the spring and damping characteristics. A full vehicle model with HPS is constructed to analyse the vehicle performance. The necessity of this vehicle model is shown by comparing its results with those of a simplified vehicle model. To alleviate the problem of excessive computational effort caused using the full vehicle model, surrogate models with respect to performance are developed for the design optimisation of HPS. By performing a multi-objective optimisation of the HPS design, a Pareto front considering the contradiction between the comfort and stability of the performances is obtained.
1 December 2018 in Advances in Engineering Software
1 August 2021 in Knowledge-Based Systems
14 September 2024 in Computer Methods in Applied Mechanics and Engineering
4 September 2019 in IEEE Access
Faults in vehicle sensor connectors are crucial to the safety of a vehicle. Once the connector is loosened according to the reduction of its contact forces, its electrical contact resistance may be increased, causing unexpected errors in sensor systems. However, such error mechanisms have enormously diverse causes that have not yet been identified. This study proposes a process to analyze the causes influencing the connector contact force and resistance by employing a combination of numerical and experimental methods. Specifically, the causes of variation of contact force are numerically analyzed and their influence on the electrical contact resistance is experimentally studied. Precise 3D models of a commercial vehicle sensor connector are developed based on a 3D tomography, and a 3D finite element (FE) simulation is employed to estimate the connector contact force, considering plastic deformation. After classifying potential causes into three categories, two major factors are selected: manufacturing tolerance occurring during the connector manufacturing process and plastic deformation occurring during the vehicle maintenance process. The factors are observed to substantially reduce the contact force (by ~14.6 or 19%). The impact of the reduced contact force is validated in sequential experiments, and exhibits a nonlinear relationship between the contact force and corresponding contact resistance. In addition, the experiments also consider simulated manufacturing and maintenance factors, and demonstrate an increased contact resistance by the functions of the decreased contact force with minor measurement errors (<; 7.5%).