1 June 2021 in IOP Conference Series: Earth and Environmental Science
Since September 2020, General Secretary Xi Jinping has made seven solemn promises to the world that China will achieve “carbon peak” by 2030 and “carbon neutral” by 2060. Under the guidance of carbon peak and carbon neutral targets, it has become an inevitable choice for China to accelerate green and low-carbon development. Developed countries started earlier on the road of emission reduction and have accumulated rich experience with relatively sound relevant laws and regulations. This paper studies and analyzes the emission reduction status of developed countries, and summarizes and summarizes the practical experience that can be used for reference from five aspects: scientific planning of emission reduction path, establishment and improvement of institutional system, gradual improvement of carbon price mechanism, breakthrough in energy conservation and emission reduction technology, and comprehensive implementation of circular economy. On this basis, combining with the current situation of economic and social development in China, Suggestions are put forward from four aspects: policy guidance, market mechanism, technological innovation and circular economy.
1 January 2019 in Shock and Vibration
The method chosen to conduct vehicle dynamic modeling has a significant impact on the evaluation and optimization of ride comfort. This paper summarizes the current modeling methods of ride comfort and their limitations. Then, models based on nonlinear damping and equivalent damping and the multibody dynamic model are developed and simulated in Matlab/Simulink and Adams/Car. The driver seat responses from these models are compared, showing that the accuracy of the ride comfort model based on nonlinear damping is higher than the one based on equivalent damping. To improve the reliability of ride comfort optimization and analysis, a ride comfort optimization method based on nonlinear damping and intelligent algorithms is proposed. The sum of the frequency‐weighted RMS of the driver seat acceleration, the RMS of dynamic tyre load, and suspension working space is taken as the objective function in this article, using nonlinear damping coefficients and stiffness of suspension as design variables. By applying the particle swarm optimization (PSO), cuckoo search (CS), dividing rectangles (DIRECT), and genetic algorithm (GA), a set of optimal solutions are obtained. The method efficiency is verified through a comparison between frequency‐weighted RMS before and after optimization. Results show that the frequency‐weighted RMS of driver seat acceleration, RMS values of the suspension working space of the front and rear axles, and RMS values of the dynamic tyre load of front and rear wheels are decreased by an average of 27.4%, 21.6%, 25.0%, 19.3%, and 22.3%, respectively. The developed model is studied in a pilot commercial vehicle, and the results show that the optimization method proposed in this paper is more practical and features improvement over previous models.
1 December 2023 in Communications in Nonlinear Science and Numerical Simulation
26 December 2019 in IEEE Access
The performance of a suspension system is affected by the behavior and posture of its components. However, published studies usually conduct this research using the based-equivalent model without considering the characteristic curves or postures. In this paper, an improved ride comfort model that considers three nonlinearities in suspensions is first developed, and this model is validated through experimental results and demonstrates good accuracy. Then, the dynamic response is presented to investigate the effects of multilevel suspension parameters and nonlinear factors on ride comfort, and it is concluded that the front chassis suspension is the most significant system for ride comfort. Next, a multivariable co-optimization method based on the improved model is proposed to obtain more accurate optimized results that are more suitable for automotive applications. Subsequently, a multiobjective genetic algorithm (MGA) is applied to obtain the Pareto solution set. Furthermore, comparing the RMS value before and after optimization shows an obvious reduction, with averages of 19.7%, 17.8%, and 12.0% for the weighted root mean square (RMS) of the driver seat acceleration and the RMS of the working spaces of the front chassis suspension and the rear chassis suspension, respectively. Finally, the results are also verified by experiments, indicating that the improved ride comfort model and the multivariable co-optimization method are feasible and practical.