12 November 2025 in Vestnik of Samara State Technical University. Technical Sciences Series
The article considers the issue of increasing the efficiency of the method for monitoring the condition of the road surface of the urban agglomeration. An integrated approach based on the use of a prototype, including an accelerometer and a GPS device installed on public transport, is considered. The purpose of the study is to substantiate the efficiency criterion of the integrated method for monitoring the condition of the road surface based on accelerometer signals and a fuzzy logic device that provides daily analysis of the dynamics of changes in the condition of the road surface and increases the efficiency of decision-making on its repair in Belgorod. The proposed method allows daily analysis of the dynamics of changes in the road surface and timely decision-making related to repair activities. To classify the condition of the roads, a fuzzy logic device is used, which provides an objective assessment in five categories from «very bad» to «very good» road surface condition. A comparative analysis with traditional methods (visual inspections, laser scanning) showed the advantages of the new method: higher frequency of inspections (daily), full route coverage and no need for special road conditions (e.g. lane closures). One of the criteria for the effectiveness of the method is efficiency, which allows calculating the dimensionless efficiency coefficient. The results of the study demonstrate that the proposed method is highly effective and can be integrated into a smart city system, GIS, and repair planning systems. The method is promising for use in conditions of limited budgets and the need to control the quality of the road surface.
1 October 2025 in Proceedings of the Southwest State University
Purpose of research. The purpose of this research is to improve the accuracy of monitoring the condition of the road surface of an urban agglomeration by analyzing accelerometer signals in real time based on the developed integrated method for assessing evenness indicators.Methods. The following methods were used in this research: analysis of existing methods for monitoring road surface conditions; methods and algorithms for filtering accelerometer signal noise (a model for preprocessing accelerometer signals was developed and described, including a Butterworth low-pass filter, a median filter, an exponential smoothing method, and calculation of threshold values); fuzzy logic algorithms (a model for classifying road surface conditions into 5 categories was developed); simulation modeling (test runs were conducted using the author's simulation model developed in the Unity environment).Results. The presented method provides automated monitoring of the road surface condition with an accuracy of at least 93%, and the possibility of integration into the smart city system. The method allows monitoring the road surface condition in real time, and the classification of the road surface condition is of a recommendatory nature for road repairs. The prospects of the research include conducting a full-scale experiment, visualizing data with reference to a city map, and using trajectory clustering algorithms to determine the general trajectories of a vehicle when going around uneven surfaces.Conclusion. Based on the developed method of monitoring the condition of the road surface, an integrated assessment of the compliance of the accuracy of monitoring the condition of the road surface of at least 93% was obtained.