Armen S. Kuzanyan

Armen S. Kuzanyan

Auto-generated profile, based on publicly available information

Armen S. Kuzanyan

National Academy of Sciences of Armenia, Institute for Physical Research, Ashtarak, Armenia

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 June 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
Astghik KuzanyanAstghik Kuzanyan
Astghik Kuzanyan
VNVahan Nikoghosyan
Vahan Nikoghosyan
AKA. S. Kuzanyan
A. S. Kuzanyan
We present the results of modeling and simulation of heat propagation processes taking place in SiO2/W/CeB6/W four-layer detection pixel of a thermoelectric single-photon detector after simultaneous absorption of two, three, and four photons with energy 0.8 eV at different distances from each other as well as many photons absorption at different optical delay. Calculations were carried out based on the equation of heat propagation from a limited volume using the three-dimensional matrix method for differential equations. We have shown that a thermoelectric detector is able to count the number of absorbed photons. Detection pixels of usable size and high detection efficiency are found to have a count rate up to 1014 cps.

1 January 2024 in Optical Engineering
Verified
Journal Article
Closed access
PDF file
Astghik KuzanyanAstghik Kuzanyan
Astghik Kuzanyan
VNVahan Nikoghosyan
Vahan Nikoghosyan
AKArmen S. Kuzanyan
Armen S. Kuzanyan
In this paper, we present the results of simulating heat propagation processes in the thermoelectric detection pixel after absorbing single photons of UV radiation with energies ranging from 7.1 to 124 eV. The detection pixels, with an operating temperature of 1 K, consist of an absorber (W), a thermoelectric sensor (La0.99Ce0.01B6), a heat sink (W), and a substrate (Al2O3). The heat transfer processes in the detection pixels with different layer thicknesses and surface areas were modeled and simulated using the three-dimensional matrix method for differential equations based on the equation of heat propagation from a limited volume. The temporal dependencies of the temperature at various points in the detection pixels and the average temperature of the layers’ surfaces were calculated. The main signal parameters, such as the maximum value, time to the peak value, decay time, full width at half maximum, and signal power, were determined. In addition, the phonon noise, Johnson noise, and the total noise equivalent power of the detection pixels were calculated. The data obtained show how the signal-to-noise ratio (SNR) depends on the energy of the absorbed photon, the geometry of the detection pixel, and the bandwidth of the signal measurement. Moreover, it was observed that the SNR exceeds unity multiple times for the absorption of photons of all considered energies in the detection pixel with a surface area of 1μm2.

11 August 2025 in IEEE Sensors Journal
Verified
Journal Article
Closed access
Astghik KuzanyanAstghik Kuzanyan
Astghik Kuzanyan
VNVahan R. Nikoghosyan
Vahan R. Nikoghosyan
AKArmen S. Kuzanyan
Armen S. Kuzanyan
We investigated the characteristics of a thermoelectric multilayer sensor of a single-photon detector in the design of which conventional superconductors Pb, Mo, and Nb are used as an absorber and a heat sink. A thermoelectric layer of lanthanum-cerium hexaboride is located between the absorber and the heat sink, and these three layers are located on a dielectric substrate. The results of computer simulation of the heat propagation process in sensors of various geometries with an operating temperature varying from 0.5 to 4.2 K are presented. The temporal dependences of the temperature in different areas of the sensor, the power of the signal arising on it, the equivalent noise power and the signal-to-noise ratio (SNR) during the absorption of single photons with an energy of 0.8, 1.65, and 3.1 eV are determined. The obtained results allow us to state that the proposed design of the sensor with a Nb superconductor can ensure the registration of absorbed single photons with a high efficiency in a wide range of the electromagnetic spectrum.

1 June 2024 in Optical Engineering
Verified
Journal Article
Closed access
PDF file
Astghik KuzanyanAstghik Kuzanyan
Astghik Kuzanyan
VNVahan Nikoghosyan
Vahan Nikoghosyan
AKArmen S. Kuzanyan
Armen S. Kuzanyan
Using modeling and computer simulation techniques, we conducted a comprehensive analysis of heat propagation processes and noise determination in a nanoscale three-layer detection pixel of a thermoelectric single-photon detector. The detection pixel comprises an absorber, a thermoelectric sensor, and a heat sink stacked on top of each other on a dielectric substrate. Our research was aimed at studying the spread of heat inside the detection pixel following the absorption of single photons with energies ranging from 0.8 to 7.1 eV (1550–175 nm) in tungsten or molybdenum absorbers of various thicknesses. The simulation was executed based on the equation for heat propagation within a limited volume. We explored temporal temperature variations in different regions of the detection pixel and analyzed the average temperature gradient across the sensor and heat sink surfaces. Parameters such as signal power resulting from the photon absorption, equivalent noise power, and signal-to-noise ratio were determined. Our results indicate that detection pixels consisting of W or Mo absorbers, a thermoelectric sensor La0.99Ce0.01B6, and a Mo heat sink, with a 15 nm thick absorber and a surface area of 1 μm2, can effectively detect single photons across a broad spectrum from far ultraviolet to near infrared. The calculated signal-to-noise ratios and temporal characteristics indicate the possibility of using this thermoelectric detection pixel design in optical microchips and large-scale multi-pixel cameras.