Friedrich Hawemann

Friedrich Hawemann

Auto-generated profile, based on publicly available information

Friedrich Hawemann

Department of Earth Sciences ETH Zurich Zurich Switzerland

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 January 2019 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
FHF. Hawemann
F. Hawemann
NMN. S. Mancktelow
N. S. Mancktelow
GPGiorgio Pennacchioni
Giorgio Pennacchioni
SWS. Wex
S. Wex
ACA. Camacho
A. Camacho
The strike‐slip Davenport Shear Zone in Central Australia developed during the Petermann Orogeny (~550 Ma) in an intracontinental lower crustal setting under dry subeclogite facies conditions (~650 °C, 1.2 GPa). This approximately 5‐km‐wide mylonite zone encloses several large low‐strain domains, allowing a detailed study of the initiation of shear zones and their progressive development. Quartzo‐feldspathic gneisses and granitoids contain compositional layers, such as quartz‐rich pegmatites, mafic bands, and dykes, which should preferentially localize viscous deformation if favorably orientated. This is not observed, except for long, continuous, and fine‐grained dolerite dykes. Instead, many shear zones, typically a few millimeters to centimeters in width but extending for tens of meters, commonly exploited pseudotachylytes and are sometimes parallel to a network of little overprinted fractures. The recrystallized mineral assemblage in the sheared pseudotachylyte is similar to that in the host gneiss, without associated hydration due to fluid‐rock interaction. Lack of localization in quartz‐rich, coarser‐grained (typically >50 μm) rocks compared to mafic dykes, precursor fractures, and pseudotachylytes implies that localization in the dry lower crust preferentially occurs along elongate, planar fine‐grained layers. Transient high stress repeatedly initiated fractures, providing finer‐grained, weaker, planar precursors that localized subsequent ductile shear zones. This intimate interplay between brittle and ductile deformation suggests a local source for lower crustal earthquakes, rather than downward migration of earthquakes from the shallower, usually more seismogenic part of the crust.

9 May 2018 in Solid Earth
Verified
Journal Article
Open access
PDF file
FHFriedrich Hawemann
Friedrich Hawemann
NMNeil S. Mancktelow
Neil S. Mancktelow
SWSebastian Wex
Sebastian Wex
ACAlfredo Camacho
Alfredo Camacho
GPGiorgio Pennacchioni
Giorgio Pennacchioni
Geophysical evidence for lower continental crustal earthquakes in almost all collisional orogens is in conflict with the widely accepted notion that rocks, under high grade conditions, should flow rather than fracture. Pseudotachylytes are remnants of frictional melts generated during seismic slip and can therefore be used as an indicator of former seismogenic fault zones. The Fregon Subdomain in Central Australia was deformed under dry sub-eclogitic conditions of 600–700 °C and 1.0–1.2 GPa during the intracontinental Petermann Orogeny (ca. 550 Ma) and contains abundant pseudotachylyte. These pseudotachylytes are commonly foliated, recrystallized, and cross-cut by other pseudotachylytes, reflecting repeated generation during ongoing ductile deformation. This interplay is interpreted as evidence for repeated seismic brittle failure and post- to inter-seismic creep under dry lower-crustal conditions. Thermodynamic modelling of the pseudotachylyte bulk composition gives the same PT conditions of shearing as in surrounding mylonites. We conclude that pseudotachylytes in the Fregon Subdomain are a direct analogue of current seismicity in dry lower continental crust.

9 October 2019 in Solid Earth
Verified
Journal Article
Open access
PDF file
FHFriedrich Hawemann
Friedrich Hawemann
NMNeil Mancktelow
Neil Mancktelow
SWSebastian Wex
Sebastian Wex
GPGiorgio Pennacchioni
Giorgio Pennacchioni
ACAlfredo Camacho
Alfredo Camacho
Garnet is a high-strength mineral compared to other common minerals such as quartz and feldspar in the felsic crust. In felsic mylonites, garnet typically occurs as porphyroclasts that mostly evade crystal plastic deformation, except under relatively high-temperature conditions. The microstructure of granulite facies garnet in felsic lower-crustal rocks of the Musgrave Ranges (Central Australia) records both fracturing and crystal plastic deformation. Granulite facies metamorphism at ∼1200 Ma generally dehydrated the rocks and produced millimetre-sized garnets in peraluminous gneisses. A later ∼550 Ma overprint under sub-eclogitic conditions (600–700 ∘C, 1.1–1.3 GPa) developed mylonitic shear zones and abundant pseudotachylyte, coeval with the neocrystallization of fine-grained, high-calcium garnet. In the mylonites, granulite facies garnet porphyroclasts are enriched in calcium along rims and fractures. However, these rims are locally narrower than otherwise comparable rims along original grain boundaries, indicating the contemporaneous diffusion and fracturing of garnet. The fractured garnets exhibit internal crystal plastic deformation, which coincides with areas of enhanced diffusion, usually along zones of crystal lattice distortion and dislocation walls associated with subgrain rotation recrystallization. The fracturing of garnet under dry lower-crustal conditions, in an otherwise viscously flowing matrix, requires transient high differential stress, most likely related to seismic rupture, consistent with the coeval development of abundant pseudotachylyte. Highlights. Garnet is deformed by fracturing and crystal plasticity under dry lower-crustal conditions. Ca diffusion profiles indicate multiple generations of fracturing. Diffusion is promoted along zones of higher dislocation density. Fracturing indicates transient high-stress (seismic) events in the lower continental crust.

13 November 2017 in Tectonics
Verified
Journal Article
Open access
PDF file
SWS. Wex
S. Wex
NMN. S. Mancktelow
N. S. Mancktelow
FHF. Hawemann
F. Hawemann
ACA. Camacho
A. Camacho
GPGiorgio Pennacchioni
Giorgio Pennacchioni
The Musgrave Block in central Australia exposes numerous large‐scale mylonitic shear zones developed during the intracontinental Petermann Orogeny around 560–520 Ma. The most prominent structure is the crustal‐scale, over 600 km long, E‐W trending Woodroffe Thrust, which is broadly undulate but generally dips shallowly to moderately to the south and shows an approximately top‐to‐north sense of movement. The estimated metamorphic conditions of mylonitization indicate a regional variation from predominantly midcrustal (circa 520–620°C and 0.8–1.1 GPa) to lower crustal (~650°C and 1.0–1.3 GPa) levels in the direction of thrusting, which is also reflected in the distribution of preserved deformation microstructures. This variation in metamorphic conditions is consistent with a south dipping thrust plane but is only small, implying that a ≥60 km long N‐S segment of the Woodroffe Thrust was originally shallowly dipping at an average estimated angle of ≤6°. The reconstructed geometry suggests that basement‐cored, thick‐skinned, midcrustal thrusts can be very shallowly dipping on a scale of many tens of kilometers in the direction of movement. Such a geometry would require the rocks along the thrust to be weak, but field observations (e.g., large volumes of syntectonic pseudotachylyte) argue for a strong behavior, at least transiently. Localization on a low‐angle, near‐planar structure that crosscuts lithological layers requires a weak precursor, such as a seismic rupture in the middle to lower crust. If this was a single event, the intracontinental earthquake must have been large, with the rupture extending laterally over hundreds of kilometers.

11 July 2018 in Solid Earth
Verified
Journal Article
Open access
PDF file
SWSebastian Wex
Sebastian Wex
NMNeil S. Mancktelow
Neil S. Mancktelow
FHFriedrich Hawemann
Friedrich Hawemann
ACAlfredo Camacho
Alfredo Camacho
GPGiorgio Pennacchioni
Giorgio Pennacchioni
Thrust fault systems typically distribute shear strain preferentially into the hanging wall rather than the footwall. The Woodroffe Thrust in the Musgrave Block of central Australia is a regional-scale example that does not fit this model. It developed due to intracontinental shortening during the Petermann Orogeny (ca. 560–520 Ma) and is interpreted to be at least 600 km long in its E–W strike direction, with an approximate top-to-north minimum displacement of 60–100 km. The associated mylonite zone is most broadly developed in the footwall. The immediate hanging wall was only marginally involved in the mylonitization process, as can be demonstrated from the contrasting thorium signatures of mylonites derived from the upper amphibolite facies footwall and the granulite facies hanging wall protoliths. Thermal weakening cannot account for such an inverse deformation gradient, as syn-deformational P–T estimates for the Petermann Orogeny in the hanging wall and footwall from the same locality are very similar. The distribution of pseudotachylytes, which acted as preferred nucleation sites for shear deformation, also cannot provide an explanation, since these fault rocks are especially prevalent in the immediate hanging wall. The most likely reason for the inverted deformation gradient across the Woodroffe Thrust is water-assisted weakening due to the increased, but still limited, presence of aqueous fluids in the footwall. We also establish a qualitative increase in the abundance of fluids in the footwall along an approx. 60 km long section in the direction of thrusting, together with a slight decrease in the temperature of mylonitization (ca. 100 °C). These changes in ambient conditions are accompanied by a 6-fold decrease in thickness (from ca. 600 to 100 m) of the Woodroffe Thrust mylonitic zone.

12 January 2026 in Proceedings of the National Academy of Sciences
Verified
Journal Article
Open access
GSGül Sürmelihindi
Gül Sürmelihindi
CPCees Passchier
Cees Passchier
MTMonika Trümper
Monika Trümper
THThomas Heide
Thomas Heide
CSChristoph Spötl
Christoph Spötl
FHFriedrich Hawemann
Friedrich Hawemann
The ancient city of Pompeii, destroyed by the eruption of Mt. Vesuvius in AD 79, shows technological improvements to its water supply after becoming a Roman colony. Its inhabitants relied on wells for their water supply prior to the installation of a Roman aqueduct. Carbonate incrustations deposited in various components of the city’s hydraulic infrastructure, including the aqueduct, its water towers, the well shafts, and pools of the public baths. The stable isotope and trace element composition of these carbonates differ markedly between structures supplied by wells and those fed by the aqueduct, reflecting the contrasting origins of their source waters. While the aqueduct was fed by karst springs, the wells tapped into highly mineralized groundwater from volcanic deposits. These geochemical distinctions allow for a detailed reconstruction of Pompeii’s water management system, particularly the transition from well- to aqueduct-based water supply. The periodicity of δ 13 C variations in carbonate crusts sampled from well, pools, and drainage channels of the Republican Baths offers insights into the operation and maintenance of the facility. δ 13 C values show a sharp drop from wells to bathing pools, suggesting contamination by human waste and implying that the bath water was not regularly replenished in the Republican Baths.