1 October 2021 in Measurement
9 April 2024 in SAE International Journal of Advances and Current Practices in Mobility
Effective design of the lubrication path greatly influences the durability of any transmission system. However, it is experimentally impossible to estimate the internal distribution of the automotive transmission fluid (ATF) to different parts of the transmission system due to its structural complexities. Hybrid vehicle transmission systems usually consist of different types of bearings (ball bearings, thrust bearings, roller bearings, etc.) in conjunction with gear systems. It is a perennial challenge to computationally simulate such complicated rotating systems. Hence, one-dimensional models have been the state of the art for designing these intricate transmission systems. Though quantifiable, the 1D models still rely heavily on some testing data. Furthermore, HEVs (hybrid electric vehicles) desire a more efficient lubrication system compared to their counterparts (Internal combustion engine vehicles) to extend the range of operation on a single charge. Thus, this paper includes a detailed, transient, three-dimensional CFD analysis of the lubricating oil flow path in an HEV transmission system using the commercial CFD software Simerics-MP+. The modeled transmission system includes scores of bearings, rotating components, and planetary gear systems. Using this modeling framework, we can predict the lubrication state of the various components of the transmission system. Furthermore, this paper reveals the effect of the centrifugal force on the oil distribution and the wetting fraction of different components. Additionally, two different designs of lubricating flow paths inside the roller bearings are explored to study the effect on the wetting of the rollers. The current simulation framework adopts the volume of fluid (VOF) technique to accurately model the two-phase interface development in the rotating systems.
1 January 2021 in Shock and Vibration
The reduced‐order model can accurately and efficiently predict unsteady problems in many aerospace engineering applications. The traditional reduced‐order model based on proper orthogonal decomposition (POD) and Galerkin projection has poor robustness and large error in predicting complex problems. In this paper, a reduced‐order model combining POD and deep learning is proposed to predict cavity flow oscillations under different flow conditions. Firstly, POD modes and corresponding coefficients are obtained by POD. Then, two deep learning frameworks, including multilayer perceptron (MLP) and long short‐term memory (LSTM) neural networks, are used to predict the future POD coefficients, respectively. Finally, the cavity flow oscillations across multi‐Mach numbers are predicted by the POD modes and the future coefficients. The results show that both of these frameworks can accurately predict cavity flow oscillations when the flow conditions change, and the time cost is reduced by order of magnitude. In addition, due to the performance of LSTM is better than that of MLP, its calculation speed is faster.
1 July 2021 in Wave Motion