1 June 2021 in Advanced Energy Materials
Transparent conductive electrodes (TCEs) are key components of photovoltaic devices. Being transparent, they allow light to enter the device, and being conductive, they allow the photocurrent generated to be drawn into the outer electric circuit. Ideally, TCEs exhibit maximum light transmission and conductivity at the same time. However, both properties have to be balanced. Depending on the photovoltaic material system, the selection of the most suitable TCE is crucial and is assessed by so‐called figures‐of‐merit (FOM). Here, a novel and exact FOM that explicitly considers the impact on photovoltaic performance is proposed. This novel FOM exhibits several useful attributes, among them: i) proportionality to the potential power output of the photovoltaic device, ii) normalization with regard to the theoretically ultimately attainable photovoltaic performance and, thus, it provides above all iii) meaningful guidance for the development of advanced TCEs. Based on the exact FOM, the transition sheet resistance is defined as the parameter, which separates the so‐far unidentified two regimes of TCE operation: transmittance versus conductance limited. An overview of realized state‐of‐the‐art semitransparent electrodes is reassessed and compared herein. Furthermore, the TCE requirements for various photovoltaic material systems are assessed in dependence on the spectral range of their operation.
1 July 2021 in Cell Reports Physical Science
17 November 2020 in Advanced Energy Materials
This Essay presents a possible pathway for the advancement of organic photovoltaics toward broader commercial success and enlarged market size. This vision aims at broad scale applications in photovoltaic greenhouses and polytunnels, which harvest those portions of the solar spectrum that are not used or required by plants. Based on the assumptions of the Shockley–Queisser–Limit, respectively detailed balance, and the additional postulation of using no absorption in the visible part of the AM 1.5G solar spectrum a power conversion efficiency of ≈17% is theoretically predicted. The suggestion is supported by the existence of a number of organic compounds, which already exhibit a good spectral compatibility with the typical photosynthetic action spectrum of chloroplasts. It is hoped that more suitable materials development shall be triggered and fertilized as a result of this Essay.
6 October 2021 in Journal of Materials Chemistry C
It is common knowledge that molecular energy level offsets of a type II heterojunction formed at the donor–acceptor interface are considered to be the driving force for photoinduced charge transfer in organic solar cells. Usually, these offsets – present between molecular energy levels of the donor and acceptor – are obtained via cyclic voltammetry (CV) measurements of organic semiconductors cast in a film or dissolved in solution. Simply transferring such determined energy levels from solution or film of single materials to blend films may be obviously limited and not be possible in full generality. Herein, we report various cases of material combinations in which novel non-fullerene acceptors did not yield successful charge transfer, although energy levels obtained by CV on constituting single materials indicate a type II heterojunction. Whilst the integer charge transfer (ICT) model provides one explanation for a relative rise of molecular energy levels of acceptors, further details and other cases have not been studied so far in great detail. By applying energy-resolved electrochemical impedance spectroscopy (ER-EIS) on several donor–acceptor combinations, a Fano-like resonance feature associated with a distinctive molecular energy level of the acceptor as well as various relative molecular energy level shifts of different kinds could be observed. By analyzing ER-EIS and absorption spectra, not only the exciton binding energy within single materials could be determined, but also the commonly unknown binding energy of the CT state with regard to the joint density of states (jDOS) of the effective semiconductor. The latter is defined by transitions between the highest occupied molecular orbitals (HOMO) of the donor and the lowest unoccupied molecular orbitals (LUMO) of the acceptor. Using this technique among others, we identified cases in which charge generation may occur either via uphill or by downhill processes between the charge transfer exciton and the electronic gap of the effective semiconductor. Exceptionally high CT-exciton binding energies and thus low charge generation yields were obtained for a case in which the donor and acceptor yielded a too intimate blend morphology, indicating π–π stacking as a potential cause for unfavorable molecular energy level alignment.
5 July 2022 in Journal of Applied Physics
JMJose Prince Madalaimuthu
+6
Current–voltage (IV) characterization is the most fundamental measurement performed on solar cells. This measurement is commonly used to extract basic solar cell parameters, such as open circuit voltage, short circuit current density, fill factor, and power conversion efficiency. We were able to obtain a fast tool to find defective behavior using Simulation Program with Integrated Circuit Emphasis simulations and generate an understanding of which device property can create such defective behaviors by analyzing the second derivative of IV curves.
5 January 2026 in Materials Chemistry Frontiers
Starch additives modulate perovskite crystallization, yielding uniform, high-quality films even under high humidity. This control boosts carbon-based PSC efficiency to 16.17% and doubles the T 80 lifetime under ISOS-L-1 testing.