We propose a very fast heterodyne technique to recover the amplitude and phase of short optical pulses generated e.g. by a mode-locked laser. A linearly swept frequency source is used to scan the entire optical spectrum of the mode-locked laser in a single continuous sweep. The beat signal is recorded on a fast oscilloscope and then digitally processed allowing the simultaneous recovery of the amplitude and the phase. This measurement is extremely fast and requires no prior spectral information about the signal under test.
In this paper, we propose and demonstrate an original exploitation of relaxation oscillations of erbium-doped-fiber laser ring resonators based on a general model for Er cross-sectional characterization. Its main advantage as compared to other existing exploitations relies on the fact that only weak approximations relative to spatial light distribution in the laser are imposed. It is therefore applicable to various resonator configurations, i.e., independent of the active-media length and losses encountered during the single-pass loop propagation. An experimental demonstration is finally presented by comparing the extracted erbium parameters (intrinsic saturation power and absorption) to those obtained with other methods.
We show that the spontaneous-emission behavior of an emitter-embedded periodic photonic band-gap (PBG) stack, described in general on the basis of the approximation of dipole emission, can be considerably modified if the macroscopic features of the emitter are considered. We have developed a model which takes into account the optical thickness of the emitter in the usual formalism. The extended model is presented in comparison with the classical dipole-emission model. Some numerical results are given and discussed, by using GaAs-embedded SiO2 / TiO2-coated quarter-wave stacks as a specific configuration. Our model provides quantitative arguments for optimization of spontaneous-emission power in terms of radiation frequency and emitter localization. It can be directly applied to optimum design of more complex systems, such as multi-emitter-embedded periodic stacks and any other passive structure.
Time-to-frequency mapping is induced on an arbitrary optical pulse by XPM using a parabolic pump pulse. The new derived condition of the peak pump pulse allows the conversion of the input pulses having different durations.