10 January 2021 in Open Access Macedonian Journal of Medical Sciences
AIM: This study aimed to evaluate the effect of gap between traditional implant tip and mental nerve using finite element analysis. METHODS: Four finite element models (FEM) were prepared for dummy crowns that were supported by traditional implants that were placed vertically in laser scanned mandibular bone geometry. Where gap distance were designed to be 1.5, 2.0, 2.5, and 3.0 mm. Dummy crown, 50 μm cement layer, and implant complex models’ components were modeled in 3D on engineering computer-aided design (CAD)/CAD (computer-aided manufacturer) software formerly collected in Finite Element Analysis package. Each model was subjected to two loading cases as 150N compressive load at central fossa, and 50N Oblique (45º) load at central fossa of the dummy crown. RESULTS: Good agreement of the FEM was obtained when compared to similar studies. Under applied study loads, all resulting values of stresses and deformations of the four models were within physiological limits. The obtained data showed no effect on cortical bone, implant complex, cement layer, and dummy crown to changing of gap distance. In addition, the cancellous bone, especially around the mental canal, was considerably affected by the variation in that gap distance. CONCLUSION: Increasing the gap distance between the dental implant tips may reduce the stress and deformation around the mental canal. Minimum gap distance of order 2.5 mm is recommended to reduce stresses and deformations around canal to favorable limits, while more gap distance is also recommended with larger bone geometries.
10 January 2021 in Open Access Macedonian Journal of Medical Sciences
Purpose: The aim of this study is to investigate the effect of the curing modes of two adhesive resin cements (Light cure mode of the Variolink Veneer, the self-cure mode and dual cure mode of the Multilink Automix) on the marginal leakage of lithium disilicate ceramic laminate veneers. Methods: A total number of forty eight extracted natural central incisors were prepared to receive ceramic laminate veneers, constructed using E-max ceramic divided into three groups cemented using three curing modes of two adhesive resin cements {light-cure mode of Variolink Veneer, self-cure mode of Multilink Automix and dual-cure mode of Multilink Automix adhesive resin cements} . Die penetration test was done using the methylene blue stain {qualitative assessment} for testing the die penetration along the tooth/ceramic interface. Results: Descriptive statistical analysis revealed that the self-curing mode recorded the significantly least degree of leakage compared to the light and dual cure modes. The self-cure mode recorded (0.1±0.3) which was significantly lower than light cure (1.2 ±0.9) and dual cure mode (1.2 ±0.4), there was no statistical significant difference between the later two curing modes. The self-cure mode of the resin cement is considered a more effective method for having the least marginal leakage at the tooth/ceramic interface. There was no difference between the light cure mode and the dual cure mode.