1 January 2010 in Progress In Electromagnetics Research
1 September 2009 in IEEE Transactions on Microwave Theory and Techniques
In this paper, a design technique to match lumped resistors in the dc to 20-GHz band is presented. This technique makes it possible to implement very wideband matched loads with a return loss that is better than 20 dB. The proposed implementation is simple, low cost, and gives superior performance than previously reported alternatives. The technique was developed to match surface-mount resistors soldered on plastic substrates, and was then successfully applied to match trimmed printed resistors on low-temperature co-fired ceramic substrates.
1 January 2012 in Progress In Electromagnetics Research B
JGJuan Carlos Gonzalez-Delgado
Juan Carlos Gonzalez-Delgado
20 March 2014 in International Journal of RF and Microwave Computer-Aided Engineering
This article presents a simple topology for the implementation of cross‐couplings between nonadjacent resonators in interdigital stripline filters. This topology affords the inclusion of transmission zeros maintaining a cross‐sectional structure similar to that of a stripline. Therefore, the manufacturing cost is very close to an all‐pole prototype. Two design strategies for the coupling structure are discussed: one of them achieving filters with enhanced performance. Both strategies have been assessed implementing prototypes in low‐temperature cofired ceramic (LTCC) technology. The fabricated filters exhibit operating frequencies at 5775 MHz and 8000 MHz with 2.6% and 3.75% pass‐band fractional bandwidths, respectively, and up to 60 dB IL in the rejection band. © 2014 Wiley Periodicals, Inc. Int J RF and Microwave CAE 24:560–570, 2014.