R. Renju

R. Renju

Auto-generated profile, based on publicly available information

R. Renju

Space Physics Laboratory, Vikram Sarabhai Space Center, ISRO , Thiruvananthapuram 695 022

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 June 2023 in Journal of Atmospheric and Solar-Terrestrial Physics
Verified
Journal Article
Closed access
RRR. Renju
R. Renju
CRC. Suresh Raju
C. Suresh Raju
RSR. Swathi
R. Swathi
MVMilan V.G.
Milan V.G.

5 March 2025 in Monthly Notices of the Royal Astronomical Society
Verified
Journal Article
Open access
RRR Renju
R Renju
CRC Suresh Raju
C Suresh Raju
MMManoj Kumar Mishra
Manoj Kumar Mishra
The first in situ measurements of thermal properties of lunar regolith at a high latitude location (69.36°S, 32.34°E) in the South Polar region were made by the Chandra’s Surface Thermophysical Experiment (ChaSTE) probe aboard India’s Chandrayaan-3 lander during 2023 August 24 to September 1. The probe with 10 closely spaced temperature sensors was inserted vertically into the regolith up to a depth of 10 cm to measure the lunar daytime temperature profiles. The vertical temperature gradient was independently measured by inserting the probe by 1 cm and the average value is 3.8$\pm$0.24 K cm−1 for depths ranging from 2 to 10 cm at $\sim$09:00 Lunar Local Time (lt). Sub-zero temperature (in $^{\circ }$C) exists within the 10 cm layer prior to $\sim$10 LT. The daytime temperature variations show a systematic phase delay with depth: the warmest temperature is attained at 12 LT near the surface while that is attained at 14:40 LT at 10 cm depth. The daytime temperature variations, the significant lapse rate changes with depth, and. the phase progression of the diurnal variation observed up to 10 cm depth, provide important insight into the influence of surface heat flux further deeper into the regolith layer as well as the thermal properties of the high latitude region. The daytime variations of the in situ measured temperature are affected by local topography, solar radiation reflected from the lander body, the infrared emission from the lander and lunar surface heat flux reflected by the lander, which are estimated in this study to be $\sim$40 per cent. This information is critical for planning future lander missions.

19 October 2026 in Monthly Notices of the Royal Astronomical Society
Verified
Journal Article
Open access
RRR Renju
R Renju
HKHarish C Kumawat
Harish C Kumawat
CRC Suresh Raju
C Suresh Raju
ChaSTE, onboard the Vikram lander of the Chandrayaan-3 mission, is designed for in-situ measurements of thermal conductivity (K) and temperature profiles of the lunar regolith with minimal disturbance. The thermal probe with 10 Resistance Temperature Detector (RTD) sensors is used to measure continuous daytime lunar regolith temperature profiles to a depth of 10 cm and a 0.1 W heater foil is used to conduct heating experiments at depths of $\sim$4 and $\sim$8 cm. The estimated slopes from the heating curve are 3.2 and 5.4 K s−1 at $\sim$8 and $\sim$4 cm, respectively. The K values determined were distinctly low $\sim$0.004 W m−1 K−1 at $\sim$4 cm depth compared to those at $\sim$8 cm depth ($\sim$0.02 W m−1 K−1), indicating layering of the lunar regolith. An exponential increase in the motor current during the probe penetration below $\sim$6 cm depth further substantiates the impact induced stratification of the regolith.